M37753M6C-XXXFP Datasheet, PDF (11/13 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

80P6N (80-PIN QFP) MARK SPECIFICATION FORM
Mitsubishi IC catalog name
Please choose one of the marking types below (A, B, C), and enter the Mitsubishi IC catalog name and the special mark (if needed).
A. Standard Mitsubishi Mark
64
65
41
40
Mitsubishi product number
(6-digit, or 7-digit)
Mitsubishi IC catalog name
80
1
25
24
B. Customer’s Parts Number + Mitsubishi IC Catalog Name
64
65
41
40
80
1
25
24
Customer’s Parts Number
Note : The fonts and size of characters are standard Mitsubishi type.
Mitsubishi IC catalog name
Notes 1 : The mark field should be written right aligned.
2 : The fonts and size of characters are standard Mitsubishi type.
3 : Customer’s parts number can be up to 14 alphanumeric char-
acters for capital letters, hyphens, commas, periods and so on.
C. Special Mark Required
64
65
80
1
41
40
25
24
Notes1 : If special mark is to be printed, indicate the desired lay-
out of the mark in the left figure. The layout will be
duplicated technically as close as possible.
Mitsubishi product number (6-digit, or 7-digit) and Mask
ROM number (3-digit) are always marked for sorting the
products.
2 : If special character fonts (e,g., customer’s trade mark
logo) must be used in Special Mark, check the box be-
low.
For the new special character fonts, a clean font original
(ideally logo drawing) must be submitted.
Special character fonts required