|
S7G2 Datasheet, PDF (1/116 Pages) Renesas Technology Corp – 32-bit ARM Cortex-M4 microcontroller | |||
|
Features
S7G2 MCU (High-performance MCU)
32-bit ARM® Cortex®-M4 microcontroller
Leading performance 240-MHz ARM Cortex-M4 microcontroller, up to 4-MB code flash memory, 640-KB SRAM,
Graphics LCD Controller, 2D Drawing Engine, Capacitive Touch Sensing Unit, Ethernet MAC Controller with IEEE 1588
PTP, USB 2.0 High-Speed, USB 2.0 Full-Speed, SDHI, Quad SPI, security and safety features, and advanced analog.
Features
â ARM Cortex-M4 Core with Floating Point Unit (FPU)
ï· ARMv7E-M architecture with DSP instruction set
ï· Maximum operating frequency: 240 MHz
ï· Support for 4-GB address space
ï· On-chip debugging system: JTAG, SWD, and ETM
ï· Boundary scan and ARM Memory Protection Unit (MPU)
â Memory
ï· Up to 4-MB code flash memory (80 MHz zero wait states)
ï· 64-KB data flash memory (up to 100,000 erase/write cycles)
ï· Up to 640-KB SRAM
ï· Flash Cache (FCACHE)
ï· Memory Protection Units (MPU)
ï· Memory Mirror Function (MMF)
ï· 128-bit unique ID
â Connectivity
ï· Ethernet MAC Controller (ETHERC) Ã 2
ï· Ethernet DMA Controller (EDMAC)
ï· Ethernet PTP Controller (EPTPC)
ï· USB 2.0 High-Speed Module (USBHS)
- On-chip transceiver
- USB battery charge version 1.2 supported
ï· USB 2.0 Full-Speed Module (USBFS)
- On-chip transceiver
ï· Serial Communications Interface (SCI) with FIFO Ã 10
ï· Serial Peripheral Interface (SPI) Ã 2
ï· I2C Bus Interface (IIC) Ã 3
ï· CAN module (CAN) Ã 2
ï· Serial Sound Interface (SSI) Ã 2
ï· SD/MMC Host Interface (SDHI) Ã 2
ï· Quad Serial Peripheral Interface (QSPI)
ï· IrDA interface
ï· Sampling Rate Converter (SRC)
ï· External memory bus
- 8-bit and 16-bit address width
- SDRAM support
â Analog
ï· 12-Bit A/D Converter (ADC12) with 3 sample-and-hold circuits
each, x2
ï· 12-Bit D/A Converter (DAC12) Ã 2
ï· High-Speed Analog Comparator (ACMPHS) Ã 6
ï· Programmable Gain Amplifier (PGA) Ã 6
ï· Temperature sensor (TSN)
â Timers
ï· General PWM Timer 32-Bit Enhanced High Resolution
(GPT32EH) Ã 4
ï· General PWM Timer 32-Bit Enhanced (GPT32E) Ã 4
ï· General PWM Timer 32-Bit (GPT32) Ã 6
ï· Asynchronous General-Purpose Timer (AGT) Ã 2
ï· Watchdog Timer (WDT)
â Safety
ï· SRAM parity error check
ï· Flash area protection
ï· ADC self-diagnosis function
ï· Clock Frequency Accuracy Measurement Circuit (CAC)
ï· Cyclic Redundancy Check (CRC) calculator
ï· Data Operation Circuit (DOC)
ï· Port Output Enable for GPT (POEG)
ï· Independent Watchdog Timer (IWDT)
ï· GPIO readback level detection
ï· Register write protection
ï· Main oscillator stop detection
ï· Illegal memory access
â System and Power Management
ï· Low-power modes
ï· Switching regulator
ï· Realtime Clock (RTC) with calendar and VBATT support
ï· Event Link Controller (ELC)
ï· DMA Controller (DMAC) Ã 8
ï· Data Transfer Controller (DTC)
ï· Key interrupt function (KINT)
ï· Power-on reset
ï· Low Voltage Detection (LVD) with voltage settings
â Security and Encryption
ï· AES128/192/256
ï· 3DES/ARC4
ï· SHA1/SHA224/SHA256
ï· GHASH
ï· RSA/DSA
ï· True Random Number Generator (TRNG)
â Human Machine Interface (HMI)
ï· Graphics LCD Controller (GLCDC)
ï· JPEG Codec
ï· 2D Drawing Engine (DRW)
ï· Capacitive Touch Sensing Unit (CTSU)
ï· Parallel Data Capture Unit (PDC)
â Multiple Clock Sources
ï· Main clock oscillator (MOSC) (8 to 24 MHz)
ï· Sub-clock oscillator (SOSC) (32.768 kHz)
ï· High-speed on-chip oscillator (HOCO) (16/18/20 MHz)
ï· Middle-speed on-chip oscillator (MOCO) (8 MHz)
ï· Low-speed on-chip oscillator (LOCO) (32.768 kHz)
ï· Independent Watchdog Timer OCO (15 kHz)
ï· Clock trim function for HOCO/MOCO/LOCO
ï· Clock out support
â General-Purpose I/O Ports
ï· Up to 172 input/output pins
- Up to 9 CMOS input
- Up to 163 CMOS input/output
- Up to 22 5-V tolerant input/output
- Up to 24 high current (20 mA)
â Operating Voltage
ï· VCC: 2.7 to 3.6 V
â Operating Temperature and Packages
ï· Ta = â40°C to +85°C
- 224-pin BGA (13 mm à 13 mm, 0.8 mm pitch)
- 176-pin BGA (13 mm à 13 mm, 0.8 mm pitch)
- 145-pin LGA (7 mm à 7 mm, 0.5 mm pitch)
ï· Ta = â40°C to +105°C
- 176-pin LQFP (24 mm à 24 mm, 0.5 mm pitch)
- 144-pin LQFP (20 mm à 20 mm, 0.5 mm pitch)
- 100-pin LQFP (14 mm à 14 mm, 0.5 mm pitch)
R01DS0262EU0100 Rev.1.00
Feb 23, 2016
Page 1 of 113
|
▷ |