PT6584 Datasheet, PDF (22/42 Pages) Princeton Technology Corp – LCD Driver IC

LCD Driver IC
Tel:[phone]
Fax:[phone]
URL:http://www.princeton.com.tw
PT6584
VOLTAGE DETECTION TYPE RESET CIRCUIT (VDET)
This circuit generates an output signal and resets the system when logic block power is first applied
and when the voltage drops, i.e., when the logic block power supply voltage is less than or equal to the
power down detection voltage VDET, which is 3.0V, typical. To assure that this function operates
reliably, a capacitor must be added to the logic block power supply line so that the logic block power
supply voltage VDD rise time when the logic block power is first applied and the logic block power
supply voltage VDD fall time when the voltage drops are both at least 1ms. (see Figure 3)
POWER SUPPLY SEQUENCE
The following sequences must be observed when power is turned on and off. (see Figure 3 and 4.)
• Power on: Logic block power supply(V_DD) on → LCD driver block power supply(V_LCD) on.
• Power off: LCD driver block power supply(V_LCD) off → Logic block power supply(V_DD) off.
However, if the logic and LCD driver block use a shared power supply, then the power supplies can be
turned on and off at the same time.
SYSTEM RESET
The PT6584 supports the reset methods described below. When a system reset is applied, display is
turned off, key scanning is stopped, and all the key data is reset to low. When the reset is cleared,
display is turned on and key scanning become possible.
RESET METHODS
(1) Reset at power-on and power-down
If at least 1ms is assured as the logic block supply voltage VDD rise time when logic block power is
applied, a system reset will be applied by the VDET output signal when the logic block supply voltage is
brought up. If at least 1 ms is assured as the logic block supply voltage VDD fall time when logic block
power drops, a system reset will be applied in the same manner by the VDET output signal when the
supply voltage is lowered. Note that the reset is cleared at the point when all the serial data (the display
data D1 to D220 and the control data) has been transferred, i.e., on the fall of the CE signal on the
transfer of the last direction data, after all the direction data has been transferred. However, the
above operations will be performed regardless of the state (high or low) of the /RES pin. If RES is high,
the reset will be cleared at the point the above operations are completed. On the other hand, if /RES is
low, the system will remain in the reset period as long as /RES is not set high, even if the above
operations are completed. (See Figure 3)
(2) Reset when the logic block power supply voltage is in the allowable operating range (VDD=3.3 to
6.0V). The system is reset when the /RES pin is set low, and the reset is cleared by setting /RES pin
high.
PT6584 V1.1
- 22 -
August, 2006