HZZ00101 Datasheet, PDF (8/9 Pages) Power-One – Cassette Style Mating Connectors

Accessories
Cassette Style Mating Connectors H11, H15, H15S2, H15S4
Extraction Tool for High Current
Contacts
High current plugs and jacks can be disassembled from the
moulding by means of a special Extraction Tool (H15 S2,
H15 S4). Holding the extraction tool over the centre of the
connector's female contact the outer part of the extraction
tool should be fed between the moulding and the outside of
the female contact itself. This releases the spring clip fixing
the contacts, in order to pull the contacts out of their
moulding for replacement. If the operation is performed
correctly very little force is required. Extreme care should
be taken since incorrect procedure and excessive force
could damage the tool and/or connector.
This tool is available as an accessory for both screw or
solder high current contacts.
Note: In order to avoid damage, never manipulate high
current contacts when plugged-in!
Description:
Reference:
Extraction tool
HZZ00150
Fig. 15
Extraction tool
Connector retention clips (unlocked)
Connector Retention Clips V
The retention clip V is an accessory which guarantees
secure connection even under severe vibration, as for
example in mobile applications. One connector retention
system fits to almost all units and all of the aforementioned
connector types.
The following converter series are delivered with pre-
punched holes in the back plate for fast field-mounting of
retention clips:
H, M, K, PSK, PSL, PSS, S and T (Q, LPC, P series only in
combination with Mounting Plate Q [HZZ01215])
Description:
Reference:
Delivery content:
Retentionclip (2x)
HZZ01209
2 pcs.
Connector retention clips (locked)
Fig. 16
Connector retention clips
Connector Retention Brackets CRB
An alternative to the above mentioned retention clip V is the
connector retention bracket. They are attached to the back
plate by one screw each with a torque of 20 to 30 Ncm.
Table 5: Connector Retention Bracket Survey
Connector
series
H, M, PSL
K, PSK
S, PSS
T
Q, P
LPC
Item number
[Reference]
CRB-HKMS
[HZZ01216]
CRB-Q
[HZZ01217]
Delivery
content
2 brackets
2 screws
2 washers
Fig. 17
Connector retention bracket CRB
SEP 29, 2003 revised to MAY 24, 2006
Page 8 of 9
www.power-one.com