PL611S-08 Datasheet, PDF (6/8 Pages) PhaseLink Corporation – Low-Power Programmable Quick Turn ClockTM

P (Preliminary) L611s-08
Low-Power Programmable Quick Turn Clock^TM
LAYOUT RECOMMENDATIONS
The following guidelines are to assist you with a performance optimized PCB design:
- Keep all the PCB traces to the PL611s-08 as short
as possible, as well as keeping all other traces as
far away from it as possible.
- Place a 0.01µF~0.1µF decoupling capacitor
between VDD and GND, on the component side of
the PCB, close to the VDD pin. It is not
recommended to place this component on the
backside of the PCB. Going through vias will reduce
the signal integrity, causing additional jitter and
phase noise.
- It is highly recommended to keep the VDD and
GND traces as short as possible.
- When connecting long traces (> 1 inch) to a CMOS
output, it is important to design the traces as a
transmission line or ‘stripline’, to avoid reflections or
ringing. In this case, the CMOS output needs to be
matched to the trace impedance. Usually ‘striplines’
are designed for 50Ω impedance and CMOS outputs
usually have lower than 50 Ω impedance so
matching can be achieved by adding a resistor in
series with the CMOS output pin to the ‘stripline’
trace.
- Please contact PhaseLink for additional information
on how to design outputs driving long traces or for
additional application assistance.
DFN-6L Evaluation Board
47745 Fremont Blvd., Fremont, California 94538 Tel [phone] Fax [phone] www.phaselink.com Rev 12/12/06 Page 6