ADNS-3090 Datasheet, PDF (29/38 Pages) Pixart Imaging Inc. – High-Performance Optical Mouse Sensor

PixArt Imaging Inc.
E^ͲϯϬϵϬ,ŝŐŚͲWĞƌĨŽƌŵĂŶĐĞKƉƚŝĐĂůDŽƵƐĞ^ĞŶƐŽƌ
Extended_Config
Access: Read/Write
Bit
7
Field Busy
Address: 0x0b
Reset Value: 0x00
6
5
4
3
2
Reserved Reserved Reserved Reserved Serial_NPU
1
NAGC
0
Fixed_FR
Data Type: Bit field
USAGE: Register 0x0b allows the user to change the configuration of the sensor. Shown below are the bits, their default
values, and optional values.
Field Name
Busy
Serial_NPU
NAGC
Fixed_FR
Description
Read-only bit. Indicates if it is safe to write to one or more of the following registers:
Frame_Period_Max_Bound_Upper and Lower
Frame_Period_Min_Bound_Upper and Lower
Shutter_Max_Bound_Upper and Lower
After writing to the Frame_Period_Max_Bound_Upper register, at least two frames must pass before
writing again to any of the above registers. This bit may be used in lieu of a timer since the actual frame
rate may not be known when running in auto mode.
0 = writing to the registers is allowed
1 = do not write to the registers yet
Disable serial port pull-up current sources
0 = no, current sources are on
1 = yes, current sources are off
Disable AGC. Shutter will be set to the value in the Shutter_Max_Bound registers.
0 = no, AGC is active
1 = yes, AGC is disabled
Fixed frame rate (disable automatic frame rate control). When this bit is set, the frame rate will be
determined by the value in the Frame_Period_Max_Bound registers.
0 = automatic frame rate
1 = fixed frame rate
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
PixArt Imaging Inc.
E-mail: [e-mail]
29