GTL2007 Datasheet, PDF (9/19 Pages) NXP Semiconductors – 13-bit GTL to LVTTL translator with power good control

Philips Semiconductors
GTL2007
13-bit GTL to LVTTL translator with power good control
11. Static characteristics
Table 12: Static characteristics
Recommended operating conditions; voltages are referenced to GND (ground = 0 V). T_amb = −40 °C to +85 °C
Symbol Parameter
Conditions
Min
Typ ^[1] Max
V_OH
HIGH-level output
A port; V_CC = 3.0 V to 3.6 V;
voltage
I_OH = −100 µA
[2] _{VCC − 0.2 3.0}
-
A port; V_CC = 3.0 V; I_OH = −16 mA
[2] _2.1
2.3
-
V_OL
LOW-level output
A port; V_CC = 3.0 V; I_OL = 4 mA
[2] _-
voltage
A port; V_CC = 3.0 V; I_OL = 8 mA
[2] _-
0.15 0.4
0.3
0.55
A port; V_CC = 3.0 V; I_OL = 16 mA
[2] _-
B port; V_CC = 3.0 V; I_OL = 15 mA
[2] _-
0.6
0.8
0.13 0.4
I_I
input current
A port; V_CC = 3.6 V; V_I = V_CC
-
-
±1
A port; V_CC = 3.6 V; V_I = 0 V
-
-
±1
B port; V_CC = 3.6 V; V_I = V_TT or GND
-
-
±1
I_CC
supply current
A or B port; V_CC = 3.6 V;
V_I = V_CC or GND; I_O = 0 mA
-
8
12
∆I_CC ^[3]
additional quiescent A port or control inputs; V_CC = 3.6 V;
-
current (per input)
V_I = V_CC − 0.6 V
-
500
C_io
input/output
capacitance
A port; V_O = 3.0 V or 0 V
B port; V_O = V_TT or 0 V
-
2.5
3.5
-
1.5
2.5
[1] All typical values are measured at V_CC = 3.3 V and T_amb = 25 °C.
[2] The input and output voltage ratings may be exceeded if the input and output current ratings are observed.
[3] This is the increase in supply current for each input that is at the specified LVTTL voltage level rather than V_CC or GND.
Unit
V
V
V
V
V
V
µA
µA
µA
mA
µA
pF
pF
9397 750 13264
Product data sheet
Rev. 01 — 2 June 2005
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
9 of 19