BUK136-50L Datasheet, PDF (5/7 Pages) NXP Semiconductors – Logic level TOPFET SMD version of BUK125-50L

Philips Semiconductors
Logic level TOPFET
SMD version of BUK125-50L
Product specification
BUK136-50L
TRUTH TABLE
For normal, open-circuit load and overload conditions or inadequate protection supply voltage.
Assumes proper external pull-up for flag pin. Refer to FLAG CHARACTERISTICS.
CONDITION
PROTECTION
INPUT
FLAG
Normal on-state
1
1
0
OUTPUT
ON
Normal off-state
1
0
0
OFF
Open circuit load
1
1
0
ON
Open circuit load
1
0
1
OFF
Short circuit load¹
1
1
1
OFF
Over temperature
1
X
1
OFF
Low protection supply voltage
0
1
1
ON
Low protection supply voltage
0
0
KEY ‘0’ equals low
‘1’ equals high
‘X’ equals don’t care.
1
OFF
FLAG CHARACTERISTICS
The flag is an open drain transistor which requires an external pull-up circuit.
Limits are for -40˚C ≤ T_mb ≤ 150˚C; typicals are for T_mb = 25˚C.
SYMBOL PARAMETER
CONDITIONS
Flag ‘low’
V_FSF
Flag voltage
I_FSF
Flag saturation current
Flag ‘high’
normal operation; V_PS = 5 V
I_F = 100 µA
V_FS = 5 V
overload or fault
I_FSO
V_(CL)FS
Flag leakage current
Flag clamping voltage
Application information
V_FS = 5 V
I_F = 100 µA
R_F
Suitable external pull-up
V_FF = 5 V
resistance
MIN. TYP. MAX. UNIT
-
0.8
1
V
-
10
-
mA
-
0.1 10 µA
5.5 6.2 8.5 V
-
47
-
kΩ
SWITCHING CHARACTERISTICS
T_mb = 25˚C; R_I = 50 Ω; R_IS = 50 Ω; V_DD = 15 V; resistive load R_L = 10 Ω.
SYMBOL PARAMETER
CONDITIONS
t_{d on}
Turn-on delay time
t_r
Rise time
t_{d off}
Turn-off delay time
t_f
Fall time
V_IS: 0 V ⇒ 5 V
V_IS: 5 V ⇒ 0 V
MIN.
-
-
-
-
TYP.
1.8
3.5
11
5
MAX.
5
8
30
12
UNIT
µs
µs
µs
µs
1 In this condition the protection circuit is latched. To reset the latch the protection pin must be taken low. Refer to PROTECTION SUPPLY
CHARACTERISTICS.
July 2002
5
Rev 1.000