PI3USB10LP-A Datasheet, PDF (4/8 Pages) Pericom Semiconductor Corporation – USB 2.0 High-Speed (480 Mbps) Signal Switch Targeted for Battery Powered Applications

PI3USB10LP-A
USB 2.0 High-Speed (480 Mbps) Signal Switch
Targeted for Battery Powered Applications
Test Circuit for Dynamic Electrical Characteristics
HP4396B
S1
R1
T1
HP11667A
PI3USB10LP-A
50-ohm
Test Circuit for Electrical Characteristics
6.0V
VCC
Pulse
VIN
Generator
RT
D.U.T
VOUT
200-ohm
10pF
C_L
200-ohm
Notes:
C_L = Load capacitance: includes jig and probe capacitance.
R_T = Termination resistance: should be equal to Z_OUT of the Pulse Generator
Waveform 1 is for an output with internal conditions such that the output is low except when disabled by the output control.
Waveform 2 is for an output with internal conditions such that the output is high except when disabled by the output control.
All input impulses are supplied by generators having the following characteristics: PRR ≤ MHz, Z_O = 50Ω, t_R ≤ 2.5ns, t_F ≤ 2.5ns.
The outputs are measured one at a time with on transition per measurement.
Switch Positions
Test
t_PLZ, t_PZL (output on I-side)
t_PHZ, t_PZH (output on I-side)
Prop Delay
Switch
6.0V
GND
Open
07-0096
4
PS8858G
05/02/07