 English |
|
|
|
|
|
|
|
| PI3USB10LP-A Datasheet, PDF (3/8 Pages) Pericom Semiconductor Corporation – USB 2.0 High-Speed (480 Mbps) Signal Switch Targeted for Battery Powered Applications | |||
| |||
| ◁ |
PI3USB10LP-A
USB 2.0 High-Speed (480 Mbps) Signal Switch
Targeted for Battery Powered Applications
Capacitance (TA = 25°C, f = 1MHz)
Parameters(3)
Description
CIN
Input Capacitance
COFF
Port I Capacitance, Switch OFF
CON
Switch Capacitance, Switch ON
Test Conditions(1)
VSEL = 0V
Typ.(2)
3.6
3.0
5.5
Max.
Units
pF
Dynamic Electrical Characteristics Over the Operating Range
Parameters
Description
Test Conditions
XTALK
OIRR
Crosstalk
OFF Isolation
RL = 50Ω, f = 250 MHz
BW
â3dB Bandwidth
RL = 50Ω
BW
â0.5dB Bandwidth
RL = 50Ω
Min.
Typ.(2)
â40
â34
1,000
270
Max.
Notes:
1. For max. or min. conditions, use appropriate value speciï¬ed under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.
3. This parameter is determined by device characterization but is not production tested.
Units
dB
MHz
MHz
Switching Characteristics
Parameters
Description
tPD
Propagation Delay(2,3)
tPZH, tPZL Line Enable Time - SEL to D(+/-), D(+/-)n
tPHZ, tPLZ Line Disable Time - SEL to D(+/-), D(+/-)n
tSKC-C Output skew, channel-to-channel(2)
tSKb-b
Output skew, bit-to-bit (opposite transition of the same
output (tPHL-tPLH)(2)
Test Conditions (1) Min.
See Test Circuit for 0.5
Electrical Charac-
teristics
0.5
Typ. Max. Units
0.25
15.0 ns
9.0
3.5 14
7.5 20 ps
Notes:
1. For max. or min. conditions, use appropriate value speciï¬ed under Electrical Characteristics for the applicable device type.
2. Guaranteed by design.
3. The switch contributes no propagational delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The time
constant for the switch alone is of the order of 0.25ns for 10pF load. Since this time constant is much smaller than the rise/fall times of typical
driving signals, it adds very little propagational delay to the system. Propagational delay of the switch when used in a system is determined by
the driving circuit on the driving side of the switch and its interactions with the load on the driven side.
07-0096
3
PS8858G
05/02/07
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese