PI3USB14 Datasheet, PDF (2/9 Pages) Pericom Semiconductor Corporation – Low Voltage, High Bandwidth, USB 2.0, 4:1 Mux/DeMux with Single Enable

PI3USB14
Low Voltage, High Bandwidth, USB 2.0,
4:1 Mux/DeMux with Single Enable
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ................................................ –65°C to +150°C
Ambient Temperature with Power Applied ............... –40°C to +85°C
Supply Voltage to Ground Potential ........................... –0.5V to +4.6V
DC Input Voltage ........................................................ –0.5V to +6.0V
DC Output Current................................................................... 120mA
Power Dissipation ....................................................................... 0.5W
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This
is a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics, 3.3V Supply (Over the Operating Range, TA = –40°C to +85°C, VCC = 3.3V ±10%)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ.⁽²⁾ Max. Units
V_IH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
V_IL
Input LOW Voltage
Guaranteed Logic LOW Level
0.8
V
V_IK
I_IH
I_IL
I_OZH
R_ON
Clamp Diode Voltage
Input HIGH Current
Input LOW Current
High Impedance Output Current
Switch On-Resistance⁽⁴⁾
V_CC = Min., I_IN = –18 mA
V_CC = Max., V_IN = V_CC
V_CC = Max., V_IN = GND
0 ≤ Y, In ≤ V_CC
V_CC = Min., V_IN = 0.0V,
I_ON = 48 mA or -64mA
V_CC = Min., V_IN = 3.6V, I_ON = -15 mA
-1.3 –1.8
±1
±1 µA
±1
4
6
Ω
5
8
DC Electrical Characteristics, 2.5V Supply (Over Operating Range, T_A = –40°C to +85°C, V_CC = 2.5V ± 10%)
Parameters⁽⁵⁾
Description
Test Conditions
Min. Typ.
Max.
Units
V_IH
Input HIGH Voltage
Guaranteed Logic HIGH Level
1.8
V_CC + 0.3
V_IL
Inout LOW Voltage
Guaranteed Logic LOW Level
–0.3
0.8
V
V_IK
Clamp Diode Voltage
V_CC = Max., I_IN = –6mA
–0.7
–1.8
I_IH
Input HIGH Current
V_CC = Max., V_IN = V_CC
±1
I_IL
I_OZH
Input LOW Current
High Impedance Current⁽³⁾
V_CC = Max., V_IN = GND
0 ≤ Y, In ≤ V_CC
±1
µA
±1
V_CC = Min., V_IN = 0.0V,
R_ON
Switch On Resistance⁽⁴⁾
I_ON = –48mA
V_CC = Min., V_IN = 2.25V,
I_ON = -15mA
6
8
Ω
7
14
2
PS8760
02/01/05