PI3HDMI412FT-A Datasheet, PDF (2/12 Pages) Pericom Semiconductor Corporation – 2:1 Mux/DeMux High Bandwidth (> 5 Gbps) HDMI 1.3 Compliant Signal Switch

PI3HDMI412FT-A
2:1 Mux/DeMux High BW (> 5 Gbps)
HDMI 1.3 Compliant Signal Switch
Pin Description
Pin # (BQSOP)
2, 4, 12, 21, 23, 25, 36, 48
1, 3, 5, 8, 11, 14, 17, 20, 22,
24, 26, 31, 37, 42, 47
13
6, 7, 9, 10, 15, 16, 18, 19,
27-30, 32-35, 38-41, 43-36
Pin # (TQFN)
2, 8, 16, 18, 20, 30, 40, 42
1, 5, 10, 13, 17, 19, 21,
39, 41
9
3, 4, 6, 7, 11, 12, 14, 15,
22-29, 31-38
Pin Name
V_DD
V_SS
SEL
Dx^+/-x + CLK^+/-x
Description
+ Power supply 3.30V
- Power supply
Select pin, see truth table
Data + Clk bits for TMDS signal
Truth Table
SEL
L
H
Function
Dx → Dx^A + Dx^B pullups are active
Dx → Dx^B+ Dx^A pullups are active
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Storage Temperature...........................................................–65°C to +150°C
Supply Voltage to V_SS Potential............................................–0.5V to +2.5V
DC Input Voltage ..............................................................0V to V_DD+0.5V
DC Output Current.............................................................................120mA
Note: Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This
is a stress rating only and functional operation of the device at
these or any other conditions above those indicated in the op-
erational sections of this specification is not implied. Exposure
to absolute maximum rating conditions for extended periods
may affect reliability.
DC Power Supply Characteristics
Paramenter
Description
V_DD
Positive Power Supply
V_SS
Negative Power Supply
Min.
3.0
1.5
Max.
3.6
1.6
Units
V
V
DC Electrical Characteristics for Switching over Operating Range (T_A = –40°C to +85°C)
Paramenter
Description
Test Conditions ⁽¹⁾
Min.
Typ.⁽²⁾
Max.
V_IH(3)
V_IL(3)
Input HIGH Voltage Guaranteed HIGH level 0.65(V_DD-V_SS)+V_SS
Input LOW Voltage Guaranteed LOW level
–0.5+V_SS
0.35(V_DD-V_SS)+V_SS
V_IK
Clamp Diode Voltage V_DD=Max., I_IN=–18mA
–0.7+V_SS
–1.2+V_SS
IIH
Input HIGH Current V_DD=Max., V_IN=V_DD
±5
I_IL
Input LOW Current V_DD=Max., V_IN=V_SS
±5
Units
V
μA
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at T_A = 25°C ambient and maximum loading.
3. V_IH & V_IL are for SEL input only.
06-0309
2
PS8831C
12/18/06