EEV-FK1V222M Datasheet, PDF (9/21 Pages) Panasonic Semiconductor – DIGI-KEY CORPORATION

Engineering Draft
V-FK-E-514
7
7．Performance Characteristics
No
Item
Performance Characteristics
1 Leakage Current ≦ I=0.01CV
2 Capacitance
　I:Leakage current C:Capacitance
V:Rated voltage
Within the specified capacitance tolerance.
3 Tangent of Loss Less than the value of Partlists.
Angl e
(tanδ)
4 Charact- Step 2 Impedance Ratio:
eristics at
Less than the table 1 value of item 8
High and
ratio against step 1.
Low Tem- Step 4 Leakage Current:
perature
≦800% of the value of item 7.1.
Capacitance Change:
Within ±25% of the value in step 1.
Tangent of Loss Angle (tanδ):
≦the value of item 7.3.
5 Surge
Leakage Current:
≦the value of item 7.1.
Capacitance Change:
Within ±15% of initial measured value.
Tangent of Loss Angle (tanδ):
≦the value of item 7.3.
Appearance:
No significant change can be observed.
Test
Series Resistor : 1000Ω±10Ω
Applied Voltage : Rated voltage
Measuring : After 2 minutes
Measuring Frequency : 120Hz±20%
Measuring Circuit : Equivalent series circuit
Measuring Voltage : +1.5 V.DC ～ +2 V.DC
(≦0.5 V for A.C.)
Measuring Frequency : 120Hz±20%
Measuring Circuit : Equivalent series circuit
Measuring Voltage : +1.5 V.DC ～ +2 V.DC
(≦0.5 V for A.C.)
Step Test Temperature(℃)
Time
1
　20±2
―
2 -25℃±3℃ ,-40℃±3℃, -55℃±3℃
30 min
3
　20±2
10 min～15 min
4
105±2
30 min
5
　20±2
10 min～15 min
Impedance should be measured 120Hz±10%.
Test temperature : 15℃～35℃
Series Protective Resistance :R
=
100 ±
C
50
　 R: Protective resistance(kΩ)
C: Capacitance(μF)
Test voltage : Surge voltage item 6.5
Applied voltage 1000 cycles of 30s±5s
"ON"and 5 min 30 s"OFF".
6 Robustness of
Termination
(Tensile)
There is no damage or breakage after test.
After fixing the capacitors, the terminals are
pulled in a vertical direction.
Load is gradually increased until it reached
the value specified below and held for 10
seconds.
Pull Strength
10N
Keep time
10s±1s
Panasonic Corporation