EEV-FK1V222M Datasheet, PDF (10/21 Pages) Panasonic Semiconductor – DIGI-KEY CORPORATION

Engineering Draft
V-FK-E-514
8
No
Item
7 Vibration
8 Solderability
Performance Characteristics
Test
Capacitance :
Frequency : 10Hz～55Hz　(1 minute per cycle.)
During test, measured value shall be Total amplitudes : 1.5 mm
stabilized.(Measured several times Direction and duration of vibration :
within 30 min. before completion of
It is done in the X,Y,Z axis direction for 2
test)
hours each, with a total of 6 hours.
Appearance :
No significant change can be observed.
Capacitance Change :
Within ±5% of initial measured value.
More than 95% of the terminal surface Solder Type : H60A,H60S,or H63A(JIS Z3282)
shall be covered with new solder.
Solder Temperature : 235℃±5℃
Exclude the cross-section of
Immersing Time : 2s±0.5s
cutting lead edge.
Immersing Depth : Dip the terminals for Approx.
0.5mm～1mm thick
Flux : Approx 25% rosin(JIS K5902) in
Ethanol(JIS K8101)
9 Resistance to
Soldering heat
10 Solvent
Resistance of
the Marking
Leakage Current :
After reflow soldering (item 9)
≦the value of item 7.1.
The capacitor shall be left at room temperature
Capacitance Change :
for before measurement.
Within ±10% of initial measured value.
Tangent of Loss Angle (tanδ) :
≦the value of item 7.3.
Appearance :
No significant change can be observed.
There shall be no damage end legibly
Class of Reagent : Isopropyl Alcohol
marked. Marking can be deciphered easily. Test Temperature : 20℃～25℃
Immersing time : 30s±5s
11 Damp Heat
(steady state)
Leakage Current :
Test Temperature : 40℃±2℃
≦the value of item 7.1.
Relative Humidity : 90%～95%
Capacitance Change :
Test Duration : 240hours±8hours
Within ±15% of initial measured value.
Tangent of Loss Angle (tanδ) :
After subjected to the test, the capacitors shall
≦120% the value of item 7.3.
be left for 2 hours at room temperature and
Appearance :
room humidity prior to the measurement.
No significant change can be observed.
Panasonic Corporation