E2C-JC4CH Datasheet, PDF (16/23 Pages) Omron Electronics LLC – Separate Amplifier Sensor with Sensitivity Adjustment

E2C/E2C-H
● Mounting
Mounting the Amplifier Unit
E2C-JC4A, E2C-JC4@H
Lengthwise Mounting
(1)Secure the Mounting Bracket with the enclosed M3 screws.
(2)Slide the protrusion on the Amplifier Unit into the holes on the
Mounting Bracket.
(3)Secure the Amplifier Unit with mounting screws.
(4)Secure the cover to the case.
4
Mounting
screw
3
Mounting
Bracket
M3 screw
1
2
Mounting
base
M3
Mounting to the Side
(1)Remove the cover screw and mounting screw.
(2)Attached the enclosed M3 screw to the cover and secure the cover
to the case.
(3)Secure the Amplifier Unit with M3 screws from the side.
E2C-WH4A
Mounting Method
(1)Mount to DIN Track as shown in the following diagram.
(2)Hook part (A) at the top of the Amplifier Unit on the DIN Track first
and then press in on the Amplifier Unit in the direction indicated by
(B).
(B)
DIN Standard 35 Track
(PFP-100N or PFP-100N2)
(A)
Removing the Amplifier Unit
(3)Pull down on the track stopper (C) with a flat-blade screwdriver and
then remove the Amplifier Unit from the DIN Track. When using
DIN standard 35 track, keep other devices on the track separated
from the Amplifier Unit by at least 30 mm to facilitate mounting and
removal.
30 mm min.
1 Cover screw
Mounting screw
M3 screw
2
Mounting base
3
M3
M3 screws
After completing adjustments, attach the
enclosed caution label over the adjustment
holes to prevent adjustment mistakes.
ON'T _TOU
Track stopper
(white)
(C)
30 mm min.
16