HWW-X036T-038070-H2 Datasheet, PDF (4/5 Pages) P-tec Corporation – X36T RGB LED Wall Washers

Page 4 of 5
display values 1 through 9.
D. Master/Slave Mode:
① Choose one wall washer as the master and set its DMX address to 001.
② Choose other wall washers as slaves and assign them any DMX addresses except 001.
③ Press button "A" of the master wall washer four times to access Self-Control mode.
④ Change the mode of the master wall washer. All slave wall washers will work synchronously with the
master.
E. Parameter form of "PXY"
P
X (mode)
-
1 (Static Red)
-
2 (Static Green)
-
3 (Static Yellow)
-
4 (Static Blue)
-
5 (Static Pink)
-
6 (Static Cyan)
-
7 (Static White)
-
8 (Multi-color jumping)
-
9 (Multi-color fading)
-
A (Multi-color flashing)
Y (speed/brightness)
9 brightness levels, (brightest at 9)
9 brightness levels, (brightest at 9)
9 brightness levels, (brightest at 9)
9 brightness levels, (brightest at 9)
9 brightness levels, (brightest at 9)
9 brightness levels, (brightest at 9)
9 brightness levels, (brightest at 9)
9 speed levels, (fastest at 9)
9 speed levels, (fastest at 9)
9 speed levels, (fastest at 9)
4) How to exit the selected mode?
Press a button of your choosing and wait for around 10 seconds for the device to exit from selected mode.
The digital LED will stop flashing and the wall washer will retain the currently the selected mode and
parameter.
Wiring Diagram
www.atgelectronics.com