HWW-X036T-038070-H2 Datasheet, PDF (3/5 Pages) P-tec Corporation – X36T RGB LED Wall Washers

Page 3 of 5
4) Finish waterproof treatment at every signal connector joint. (Please refer to picture below).
5) Connect the DMX Console to the first Smart™ X36T.
6) Plug the first Smart™ X36T and DMX console into power outlets to power the system.
Operation Instruction
1) Buttons Functions
Button
Control Mode
Function
Example
DMX-Control
Displays the DMX address selected
(valid DMX addresses from 001~512)
Displays the color-changing mode and
Self-Control speed selected (P=self-control, X=mode,
Y=speed)
DMX-Control Select a parameter for configuration
-
Self-Control Select mode or speed for configuration
-
DMX-Control Set corresponding parameter
-
Self-Control Set corresponding mode/speed
-
2) How to change settings in DMX-Control mode
A. Once the wall washer is connected to the DMX console, it will access DMX-Control mode.
B. Press button "A" to select a parameter for the DMX address.
C. Press button "B" to change the DMX address.
D. Valid DMX address range: 001~512. (Refer to the user guide of the DMX Console for more detailed
information on operating the DMX Console.)
E. Each wall washer occupies three DMX channels, including red, green, and blue. For example, the wall
washer at DMX address 001 occupies channels 1, 2, and 3; the wall washer at DMX address 256
occupies channels 256, 257, and 258.
3) How to access and set under Self-Control mode
A. Press button "A" four times. This will access Self-Control mode and the letters "PXY” will be displayed.
B. Press button "A" once. The digital LED should start to flash and you will be given access to the
corresponding setup (mode).
C. Press button "B" to change the corresponding setup (speed or brightness). The digital LED should
www.atgelectronics.com