HWW-X036T-038070-H2 Datasheet, PDF (2/5 Pages) P-tec Corporation – X36T RGB LED Wall Washers

Page 2 of 5
User Responsibilities
The responsibility of complying with all state and local laws, ordinances, and regulations in regards to the
installation, maintenance, and operation of the device lies with the buyer and handler of the device.
These parties may include, but are not limited to the contractor, installer, purchaser, owner, and user of
the product.
Note:
The instructions and precautions set forth in this user guide are not necessarily inclusive of or relevant to
all applications as ATG Electronics cannot anticipate all possible situations.
PLANNING THE INSTALLATION
This device installation requires planning to ensure timely installation with minimal complications and
down time.
Planning Suggestions
Consult an electrical inspector when reviewing all wiring plans.
Create a layout plan blueprint, per a lighting designer’s or architect’s recommendations.
Consult ATG Electronics's Application Engineering Services as needed.
Installation Considerations
When creating your installation plan, consider the following:
1) Location of the device
Smart™ X36T is suitable for only dry, wet and damp environments.
2) Control System
Smart™ X36T can be controlled by DynColor™ 500-SL RGB DMX Controller. Synchronous color
changing might be considered before installing.
3) Lighting Distance
The maximum lighting distance for Smart™ X36T is around 20 meters (65 feet).
4) Maximum Series-wound Length
100 meters (328 feet). Master™ 192-SA Signal Amplifier is needed at every 100 meters (328 feet).
Installation Steps
1) Place Smart™ X36T at the required locations and aim them according to your lighting design.
2) Adjust the rotary angle to required angle.
3) Connect Smart™ X36T to each other. Signal Amplifiers are needed every 100 meters or 328 feet.
www.atgelectronics.com