MC74HC165A_16 Datasheet, PDF (6/12 Pages) ON Semiconductor – 8-Bit Serial or Parallel-Input/ Serial-Output Shift Register

MC74HC165A
PIN DESCRIPTIONS
INPUTS
A, B, C, D, E, F, G, H (Pins 11, 12, 13, 14, 3, 4, 5, 6)
Parallel Data inputs. Data on these inputs are
asynchronously entered in parallel into the internal
flip−flops when the Serial Shift/Parallel Load input is low.
SA (Pin 10)
Serial Data input. When the Serial Shift/Parallel Load
input is high, data on this pin is serially entered into the first
stage of the shift register with the rising edge of the Clock.
CONTROL INPUTS
Serial Shift/Parallel Load (Pin 1)
Data−entry control input. When a high level is applied to
this pin, data at the Serial Data input (SA) are shifted into the
register with the rising edge of the Clock. When a low level
is applied to this pin, data at the Parallel Data inputs are
asynchronously loaded into each of the eight internal stages.
Clock, Clock Inhibit (Pins 2, 15)
Clock inputs. These two clock inputs function identically.
Either may be used as an active−high clock inhibit.
However, to avoid double clocking, the inhibit input should
go high only while the clock input is high.
The shift register is completely static, allowing Clock
rates down to DC in a continuous or intermittent mode.
OUTPUTS
Q_H, Q_H (Pins 9, 7)
Complementary Shift Register outputs. These pins are the
noninverted and inverted outputs of the eighth stage of the
shift register.
ORDERING INFORMATION
Device
Package
Shipping^†
MC74HC165ANG
PDIP−16
(Pb−Free)
500 Units / Rail
MC74HC165ADG
SOIC−16
(Pb−Free)
48 Units / Rail
MC74HC165ADR2G
SOIC−16
(Pb−Free)
2500 Units / Reel
NLV74HC165ADR2G*
SOIC−16
(Pb−Free)
2500 Units / Reel
MC74HC165ADTR2G
TSSOP−16
(Pb−Free)
2500 Units / Reel
NLV74HC165ADTR2G*
TSSOP−16
(Pb−Free)
2500 Units / Reel
MC74HC165AMNTWG
QFN16
(Pb−Free)
3000 Units / Reel
†For information on tape and reel specifications, including part orientation and tape sizes, please refer to our Tape and Reel Packaging
Specifications Brochure, BRD8011/D.
*NLV Prefix for Automotive and Other Applications Requiring Unique Site and Control Change Requirements; AEC−Q100 Qualified and PPAP
Capable.
www.onsemi.com
6