NOIH2SM1000A Datasheet, PDF (1/66 Pages) ON Semiconductor – HAS2 Image Sensor

NOIH2SM1000A
HAS2 Image Sensor
INTRODUCTION
Scope
This datasheet details the ratings, physical, geometrical,
electrical and electro-optical characteristics, and test- and
inspection-data for the High Accuracy Star Tracker (HAS2)
CMOS active pixel image sensor (CMOS APS).
The device described in this document is protected by US
patent 6,225,670 and others.
Component Type Values
Table 10 on page 9 provides a summary of the type
variants. The complete list of specifications for each type
variant is given in the specifications tables.
All specifications are given at 22 ±3°C, under nominal
clocking and bias conditions. Exceptions are noted in the
‘Remarks’ field.
Maximum Rating
Table 11 on page 9 specifies the maximum ratings. Do
not exceed these ratings at any times, during use or storage.
Physical Dimension and Geometrical Information
Figure 4 on page 24 shows the physical dimensions of the
assembled component. The geometrical information in
Figure 3 on page 10 describes the position of the die in the
package.
Pin Assignment
Figure 25 on page 39 contains the pin assignment. The
figure contains a schematic drawing and a pin list. A detailed
functional description of each pin is available in Pin List on
page 35.
Soldering Instructions
Soldering is restricted to manual soldering only. No wave
or reflow soldering is allowed. For manual soldering, the
following restrictions are applicable:
• Solder 1 pin on each of the four sides of the sensor.
• Cool down for a minimum period of 1 minute before
soldering another pin on each of the four sides.
• Repeat soldering of 1 pin on each side, including a 1
minute cool down period.
Handling Precautions
The component is susceptible to damage by electro-static
discharge. Therefore, use suitable precautions for protection
during all phases of manufacture, testing, packaging,
shipment, and any handling. Follow these guidelines:
• Always manipulate devices in an ESD controlled
environment.
www.onsemi.com
• Always store the devices in a shielded environment that
protects against ESD damage (at least a non-ESD
generating tray and a metal bag).
• Always wear a wrist strap when handling the devices
and use ESD safe gloves.
• The HAS2 is classified as class 1A (JEDEC
classification - [AD02]) device for ESD sensitivity.
For proper handling and storage conditions, refer to the
ON Semiconductor application note AN52561.
Return Material Authorization (RMA)
ON Semiconductor packages its image sensor products in
a clean room environment under strict handling procedures
and ships all image sensor products in ESD-safe,
clean-room-approved shipping containers. Products
returned to ON Semiconductor for failure analysis should be
handled under these same conditions and packed in its
original packing materials, or the customer may be liable for
the product.
Storage Information
The components must be stored in a dust-free and
temperature-, humidity-and ESD-controlled environment.
• Store devices in special ESD-safe trays such that the
glass window is never touched.
• Close the trays with EDS-safe rubber bands.
• Seal the trays in an ESD-safe conductive foil in clean
room conditions.
• For transport and storage outside a clean room, pack the
trays in a second ESD-save bag that is sealed in clean
room.
Additional Information
The HAS sensor is subject to the standard European
export regulations for dual use products. A Certificate of
Conformance will be issued upon request at no additional
charge. The CoC refers to this datasheet version.
ITAR Information
All the HAS2 type variants are ITAR-free components.
© Semiconductor Components Industries, LLC, 2015
1
January, 2015 − Rev. 14
Publication Order Number:
NOIH2SM1000A/D