H3CA8DC24 Datasheet, PDF (9/16 Pages) Omron Electronics LLC – DIN-sized (48 x 48, 45 x 75 mm) Timer with Digital Setting and LCD Display

Mounting Track (Meets DIN EN50022)
PFP-100N/PFP-50N
PFP-100N2
Twelve, 25 × 4.5 elliptic holes (see note)
H3CA
(see note)
Note: This dimension applied to PFP-50N.
End Plate
PFP-M
Note: A total of 12-25 × 4.5 elliptic holes are provided with 6 holes
cut from each rail end at a pitch of 10 mm between holes.
PFP-S
Adapter for Flush Mounting
Y92F-30
Note: Pay attention to the orientation of the adapter when mounting
two or more timers in a vertical or horizontal line.
Protective Cover
Y92A-48B/Y92A-48D
The protective cover protects the front panel, particularly the
time setting section, against dust, dirt and water drip, as well
as prevents the set value from being altered due to accidental
contact with the time setting knob.
Y92A-48B
Hard Plastic Cover
Y92A-48D
Soft PVC Cover
Note: The Y92A-48B Protective Cover is made of a hard plastic and
therefore, must be removed to change the timer set value. However,
since the Y92A-48D Protective Cover is made of PVC, the set value
can be altered by pressing on the surface of the cover.
It may be, however, difficult to make setting changes of the Timer
with the Y92A-48B Protective Cover attached, which must be taken
into consideration before using the Y92A-48B Protective Cover.
When attaching the Y92A-48A to the Timer to be panel-mounted,
use the Y92F-30 Mounting Adapter along with the Timer.
The Protective Cover cannot be, however, used for the H3CA-FA
Series.
9