H3CA8DC24 Datasheet, PDF (6/16 Pages) Omron Electronics LLC – DIN-sized (48 x 48, 45 x 75 mm) Timer with Digital Setting and LCD Display

How to Use Gate Signal Input
H3CA
How to Use Check Signal Input
If a check signal is input to the timer during the lapse of a set time,
the remaining set time will become 0 and the timer will enter the
next control state. Also, while a check signal is being input, the
elapsed time measurement of the set time is not performed.
ON-delay Operation
Note: 1. This timing chart indicates the gate input in operation
mode A (ON-delay operation).
2. The set time is the sum of t1 and t2.
t: Set time; t-a: Time within the set time
Repeat Cycle Operation
H3CA-8H
t: Set time; t-a: Time within the set time
6