E2EX5ME1 Datasheet, PDF (41/48 Pages) Omron Electronics LLC – Cylindrical Proximity Sensor

E2E/E2E2
E2E-XjYj-M1 AC 2-wire Models
Output configuration
Applicable models
NO
E2E-XjY1-M1
Pin arrangement
Load
Note: Terminals 1 and 2 are not used.
NC
E2E-XjY2-M1
Load
E2E/E2E2
Load
Load
Note: Terminals 3 and 4 are not used.
Precautions
Mounting
Do not tighten the nut with excessive force. A washer must be used
with the nut.
Refer to the following to mount the E2E-CR8 and E2E-C1 non-
screw models.
8 to 21 mm
M3 hole
No screw is provided
with the E2E-CR8 or
E2E-C1.
E2E
Shielded Model
Unshielded Model
Part B Part A
Part B Part A
Note:
The table below shows the tightening torques for part A and
part B nuts. In the previous examples, the nut is on the sen-
sor head side (part B) and hence the tightening torque for
part B applies. If this nut is in part A, the tightening torque for
part A applies instead.
Type
M8 Shielded
Unshielded
M12
M18
M30
Part A
Part B
Length
Torque
Torque
9 mm
3 mm
9NSm
12 N S m
(90 kgf S cm) (120 kgf S cm)
29 N S m (300 kgf S cm)
69 N S m (700 kgf S cm)
176 N S m (1,800 kgf S cm)
Tighten the screw to a torque of 0.20 N S m (2 kgf S cm) maximum to
secure the E2E-CR8 and a torque of 0.39 N S m (4 kgf S cm) maxi-
mum to secure the E2E-C1.
E2E2
Type
M12
M18
M30
Torque
30 N S m (310 kgf S cm)
70 N S m (710 kgf S cm)
180 N S m (1,800 kgf S cm)
41