E2E-X5ME2-M1 Datasheet, PDF (31/48 Pages) Omron Electronics LLC – A New Series of Easy-to-use and Tough E2E/E2E2 Models Long-size E2E2 Proximity Sensor Conforms to CENELEC

E2E-CR8C@/CR8B@/X1C@/X1B@-M5 DC 3-wire Models
Connector
Operation mode
M8-3pin
NO/NC
Applicable models
E2E-CR8C@-M5
E2E-X1C@-M5
Pin arrangement
4
DC
13
NO/NC
E2E-CR8B@-M5
E2E-X1B@-M5
Load
4
DC
13
E2E-X@Y@-M1 AC 2-wire Models
Operation mode
NO
Applicable models
E2E-X@Y1-M1
Load
Pin arrangement
Load
Load
Note: Terminals 1 and 2 are not used.
NC
E2E-X@Y2-M1
Load
Load
Note: Terminals 3 and 4 are not used.
Precautions
Mounting
Do not tighten the nut with excessive force. A washer must be used
with the nut.
Shielded Model
Unshielded Model
Part B Part A
Part B Part A
Note: The table below shows the tightening torques for part A and
part B nuts. In the previous examples, the nut is on the sensor
head side (part B) and hence the tightening torque for part B
applies. If this nut is in part A, the tightening torque for part A
applies instead.
Model
M5
M8 Shielded
Unshielded
M12
M18
M30
Part A
Length
Torque
1 N·m
9 mm
9 N·m
3 mm
30 N·m
70 N·m
180 N·m
Part B
Torque
12 N·m
Refer to the following to mount the E2E-CR6, -CR8 and E2E-C1
non-screw models.
E2E-CR6: 9 to 21 mm
E2E-CR8, -C1: 8 to 21 mm
M3 hole
No screw is provided
with the E2E-CR6,
-CR8 or E2E-C1.
Tighten the screw to a torque of 0.2 N·m maximum to secure the
E2E-CR6, -CR8 and a torque of 0.4 N·m maximum to secure the
E2E-C1.
E2E/E2E2 Cylindrical Proximity Sensor
31