DRT2-TS04P Datasheet, PDF (3/28 Pages) Omron Electronics LLC – Remote I/O Terminals with Transistors

Control System
Ethernet
PLC
Control
information
Maintenance System
DeviceNet
Configurator
Maintenance information
Preventive maintenance
of equipment
Reliable equipment
startup
Operating time monitor
Contact operation counter
Unit conduction time monitor
Slave and connected component comments
Reduced startup time
Reduced downtime
I/O power status monitor
Network power voltage monitor
Communication error history
monitor
Unit conduction
time monitor
(See note.)
It's time for
motor
maintenance!
What is the
present
communications
voltage?
Network power
voltage monitor
DRT2-series
Smart Slave
The wiring to
the I/O device is
short-circuited
or broken!
The cylinder's
speed is
incorrect!
It might be time
for a switch
inspection!
Is the I/O
power supply
turned ON?
External load
short-circuit detection
Operating time
monitor
Contact operation
counter (See note.)
I/O power status
monitor
Note: The contact operation counter function and the unit conduction time monitor function cannot be used simultaneously.
What was the
cause
of the error?
Communication error
history monitor
Using OMRON Temperature Input Terminals for
Maintenance
Failure Prediction
and Maintenance
The operating time of a preset temperature range is counted in 1-s units.
If prolonging the
time it takes to
reach a certain
temperature may
degrade
equipment:
Short Startup
If it takes too long
to modify the
ladder program on
the Master when a
Temperature
Sensor is replaced:
Slaves can notify the
Master when a setting
is exceeded.
Indicator service
life control
Operating time
Input
Semiconductor
manufacturing equipment
Time
The peaks or valleys of temperature inputs that change in a regular pattern
are counted to predict when devices operating with severe temperature
swings are due for maintenance.
Slaves internally
convert display values
to temperature input
values so the Controller
program no longer has
to be modified to
perform this task.
Scaling performed
inside the Slave
Scaling points for 0%
and 100% are set from
the Configurator
Sensor replaced by one
with a different input range
3