S82J Datasheet, PDF (19/20 Pages) Omron Electronics LLC – Compact and Economical Switch mode Power Supplies with Capacities Up to 600W

Precautions
Mounting
To improve and maintain the reliability of the Power Supply over a
long period of time, adequate consideration must be given to heat
radiation.
The Power Supply is designed to radiate heat by means of natural
air-flow. Therefore, mount the Power Supply so that air flow takes
place around the Power Supply.
When mounting the Power Supply, mounting it to a metal plate is rec-
ommended.
When mounting two or more Power Supplies side-by-side, allow at
least 20 mm spacing between them, as shown in the following illus-
tration.
Forced air-cooling is recommended.
100 (5, 12, 15 V)/150-/300-/600-W Models
(A) Side mounting (except for 300- and 600-W models)
(B) Bottom mounting (secured with screws from the inside of the
Switching Power Supply) (except for 300- and 600-W models)
(C) Bottom mounting (secured with screws from the back of the
Switching Power Supply)
(B)
(A)
Air
20 mm min.
Metal plate
Mounting Methods
The following mounting methods are available.
10-/25-/50-/100 (24 V)-W Models
(A) Side mounting
(B) Bottom mounting
(C) Front mounting (see Accessories)
(B)
(A)
(C)
(D) Front mounting
Front mounting is possible with the mounting brackets provided.
Refer to Dimensions.
Mounting brackets
(provided)
Metal plate
Switching Power Supply S82J
L-97