E3C-S10 Datasheet, PDF (14/18 Pages) Omron Electronics LLC – Photoelectric Sensor

E3C
Connections, continued
Amplifier
model
E3C-WH4F
Sensors
Through-beam type
Diffuse reflective type
E3C-S10, E3C-S20W, E3C-S30s, E3C-S50, E3C-1, E3C-2 E3C-DS5W, E3C-DS10
E3C
Notes
NOTE: Terminals 5, 6, 7, and 8 are not used when connected to S3D8
or S3D-F sensor controllers.
*Shielded wires must not be peeled in excess of
2 cm (0.787 in) for the receiver (white lead) and 5 cm
(1.969 in) for the light source (red lead).
NOTE: Terminals 5, 6, 7, and 8 are not used when connected to S3D8
or S3D-F sensor controllers.
*Shielded wires must not be peeled in excess of
2 cm (0.787 in).
Operation
s E3C-A Amplifier
s E3C-A Timing Chart
Selection of operation mode
DARK ON
LIGHT ON When light is incident, the output relay
operates and solid-state output becomes
high (H).
DARK ON
LIGHT ON When light is interrupted, the output relay
operates and the solid-state output becomes
high (H).
NOTE: 1. Control output is produced only during the input time.
2. When t exceeds 1 ms or 2 ms, solid-state output is produced. To produce
relay contact output, t must be longer than 20 ms.
Selection of response time
2 msec (B)
2 msec (B)
1 msec (A) The response time is set to 2 ms.
1 msec (A) The response time is set to 1 ms.
15