CS1W-SPU01-V2 Datasheet, PDF (11/14 Pages) Omron Electronics LLC – High-speed Collection of System Data

External Interface
CS1W-SPU01-V2/02-V2
CS1W-SPU01/SPU02-V2
Here, the CS1W-SPU02-V2, which has two LAN ports, is taken as an example. The CS1W-SPU01-V2 has only one LAN port.
Indicators
Unit number
switch
Card button
COMM port
SPU02
RUN
ERC
ERH
COMM
UNIT 0
NO.
CARD
SW
COMM
CS
7-segment display
Card eject button
Card holder
CARD _{Card indicator}
PC card slot
PF-IN terminals
PF-IN indicator
DIP switch
PF-IN
DIPSW
Select switch
SELECT
Enter button
ENTER
LAN1
LAN indicator Recognition
LAN2
retry switch
LAN1
LAN ports
(CS1W-SPU01-V2: One port,
LAN2 ^{CS1W-SPU02-V2: Two ports)}
Name
Unit number switch (UNIT NO.)
DIP switch (DIP SW)
Card button (CARD SW)
Card eject button
Card holder
Select switch
Enter button
Indicators
Seven-segment display
LAN indicator
Card indicator
PF-IN indicator
PC card slot
Communications ports LAN1/LAN2
COMM port
PF-IN terminals
Recognition retry switch
Function
Sets the unit number of the SYSMAC SPU Unit as a one-digit hexadecimal value.
Do not set the same unit number for more than one CPU Bus Unit under the same CPU Unit.
Used for system settings.
Press this button to allow the Memory Card inserted in the PC card slot to be removed.
Press to remove the PC card.
Holds the PC card.
Sets the command to be executed. The command number will be displayed on the seven-segment
display.
Executes the command set using the select switch.
The following indicators show the operating status of the Unit: RUN, ERC, ERH, and COMM.
Displays error information and the operating status of the SYSMAC SPU Unit.
Displays the command number when the select switch is operated.
Displays the IP address and other results of command execution.
Indicates the operating status of the LAN port.
Indicates the operating status of the PC card.
Lights when the power failure input is received from a UPS or other device.
A slot used to insert a card conforming to PC Card Type II.
LAN communications ports. Connect to 10Base-T/100Base-TX cables.
For future expansion.
Connected to the power failure input from a UPS or other device.
Refer to the SYSMAC SPU Units Operation Manual (Cat. No. 236), Starting CPU Unit Operation
Immediately upon Power Application.
11