CS1W-MCH71 Datasheet, PDF (1/11 Pages) Omron Electronics LLC – Improve Equipment Design Efficiency and Shorten Tact Time

CJ-series Motion Control Unit with MECHATROLINK-II interface
CJ1W-MCH71
CSM_CJ1W-MCH71_DS_E_4_1
Improve Equipment Design Efficiency and
Shorten Tact Time
• Control Servos for up to 16 axes in a motion network with one
Position Control Unit that supports MECHATROLINK-II *
* MECHATROLINK-II is a registered trademark of the MECHATROLINK Members
Association.
CJ1W-MCH71
Features
• High-precision motion control with less wiring using MECHATROLINK-II Servo communications with superior concurrency.
• Many synchronization and axis control commands are supported to aid existing synchronized control applications and improve motion control
tact time.
• Program control commands (such as branching commands) and various arithmetic operations are supported for maximum motion programming
efficiency.
System Configuration
Programmable Terminals
NS-series
Support Tool
CX-Motion-MCH
Programmable Controller
CJ-series
30 axes max.
Motion Control Unit CJ1W-MCH71
30 axes max., overall cable length:50m
50m max.
Sensors
(limit inputs, origin
proximity inputs, etc.)
OMNUC W series
AC Servo Drives with
Built-in MECHATROLINK-II
Communications
(R88D-WN -ML2)
AC Servo motor(R88M-W)
SMARTSTEP Junior
AC Servo Drives with
Built-in MECHATROLINK-II
Communications
(R7D-ZN -ML2)
AC Servo motor(R7M-Z)
OMNUC W series
AC Servo Drive with
General-purpose Pulse
or Analog inputs
(R88D-WT)
MECHATROLINK-II
Interface Unit
(FNY-NS115)
AC Servo motor
(R88M-G)
Connect a JEPMC-W6022 Terminator to the device
at the end of the MECHATROLINK-II network.
Note: OMNUC G5 series and G series cannot be connected with CJ1W-MCH71.
1