PN7360AUHN Datasheet, PDF (54/86 Pages) NXP Semiconductors – NFC Cortex-M0 microcontroller

NXP Semiconductors
PN746X_736X
NFC Cortex-M0 microcontroller
Table 27. Limiting values for SPI master pins ( spim_nss, spim_miso, spim_mosi and spi_clk)
Symbol Parameter
Conditions
Min
Max Unit
V_i
input voltage
0.3 4.2
V
Table 28.
Symbol
V_i
Limiting values for host interfaces atx_a, atx_b, atx_c, atx_d in all configurations (USB, HSUART, SPI and
I²C)
Parameter
Conditions
Min
Max Unit
input voltage
0.3 4.2
V
Table 29. Limiting values for crystal oscillator
In accordance with the Absolute Maximum Rating System (IEC 60134).
Symbol Parameter
Conditions
V_IH
high-level input voltage
XTAL1, XTAL2
Min
Max Unit
0
2.2
V
Table 30. Limiting values for power supply
In accordance with the Absolute Maximum Rating System (IEC 60134).
Symbol Parameter
Conditions
V_DDP(VBUS) power supply voltage on pin VBUS
V_DDP(VBUSP) power supply voltage on pin VBUSP
pin supply voltage for host interface and GPIOs (on pin PVDD_IN)
V_DD(PVDD) PVDD supply voltage
on pin PVDD_IN; power supply
for host interfaces and GPIOs
pin supply voltage for master interfaces (on pin PVDD_M_IN)
V_DD(PVDD) PVDD supply voltage
on pin PVDD_M_IN; power
supply for master interfaces
RF interface LDO (pin VUP_TX)
V_I(LDO)
LDO input voltage
RF transmitter (pin TVDD_IN)
for RF interface LDO
V_DD(TVDD) TVDD supply voltage
for RF interface transmitter
Min
[1] _0.3
[1] _0.3
Max
6
6
Unit
V
V
[1] _0.3
4.2
V
[1] _0.3
4.2
V
[1] _0.3
6
V
[1] _0.3
6
V
[1] Maximum/minimum voltage above the maximum operating range and below ground that can be applied for a short time (< 10 ms) to a
device without leading to irrecoverable failure. Failure includes the loss of reliability and shorter life time of the device.
Table 31. Limiting values for contact interface
In accordance with the Absolute Maximum Rating System (IEC 60134).
Symbol Parameter
Conditions
V_IH
high-level input voltage
on card pins IO, RST, AUX1,
AUX2, CLK
Table 32.
Symbol
I_Olim
I_sd
Protection and limitations for contact interface
Parameter
Conditions
output current limit on IO, C4, C8 class A, B, C
shutdown current
on pin V_CC = 5 V
on pin V_CC = 3 V (doubler mode)
on pin V_CC = 3 V (follower mode)
on pin V_CC = 1.8 V
Min
Max Unit
0.3 5.75 V
Min Typ Max Unit
5
8
15 mA
70 85 110 mA
75 90 110 mA
75 90 110 mA
60 70 90 mA
PN746X_736X
Product data sheet
COMPANY PUBLIC
All information provided in this document is subject to legal disclaimers.
Rev. 3.1 — 5 April 2016
369231
© NXP Semiconductors N.V. 2016. All rights reserved.
54 of 86