LPC2927_10 Datasheet, PDF (1/95 Pages) NXP Semiconductors – ARM9 microcontroller with CAN, LIN, and USB

LPC2927/2929
ARM9 microcontroller with CAN, LIN, and USB
Rev. 04 — 14 April 2010
Product data sheet
1. General description
The LPC2927/2929 combine an ARM968E-S CPU core with two integrated TCM blocks
operating at frequencies of up to 125 MHz, Full-speed USB 2.0 OTG and device
controller, CAN and LIN, 56 kB SRAM, up to 768 kB flash memory, external memory
interface, three 10-bit ADCs, and multiple serial and parallel interfaces in a single chip
targeted at consumer, industrial and communication markets. To optimize system power
consumption, the LPC2927/2929 has a very flexible Clock Generation Unit (CGU) that
provides dynamic clock gating and scaling.
2. Features and benefits
„ ARM968E-S processor running at frequencies of up to 125 MHz maximum.
„ Multi-layer AHB system bus at 125 MHz with four separate layers.
„ On-chip memory:
‹ Two Tightly Coupled Memories (TCM), 32 kB Instruction TCM (ITCM), 32 kB Data
TCM (DTCM).
‹ Two separate internal Static RAM (SRAM) instances; 32 kB SRAM and 16 kB
SRAM.
‹ 8 kB ETB SRAM also available for code execution and data.
‹ Up to 768 kB high-speed flash-program memory.
‹ 16 kB true EEPROM, byte-erasable and programmable.
„ Dual-master, eight-channel GPDMA controller on the AHB multi-layer matrix which can
be used with the Serial Peripheral Interface (SPI) interfaces and the UARTs, as well as
for memory-to-memory transfers including the TCM memories.
„ External Static Memory Controller (SMC) with eight memory banks; up to 32-bit data
bus; up to 24-bit address bus.
„ Serial interfaces:
‹ USB 2.0 full-speed device/OTG controller with dedicated DMA controller and
on-chip device PHY.
‹ Two-channel CAN controller supporting FullCAN and extensive message filtering.
‹ Two LIN master controllers with full hardware support for LIN communication. The
LIN interface can be configured as UART to provide two additional UART
interfaces.
‹ Two 550 UARTs with 16-byte Tx and Rx FIFO depths, DMA support, and
RS485/EIA-485 (9-bit) support.
‹ Three full-duplex Q-SPIs with four slave-select lines; 16 bits wide; 8 locations deep;
Tx FIFO and Rx FIFO.
‹ Two I²C-bus interfaces.