MNCLC501A-X Datasheet, PDF (8/14 Pages) National Semiconductor (TI) – HIGH-SPEED OUTPUT CLAMPING OP AMP

MNCLC501A-X REV 0A0
MICROCIRCUIT DATA SHEET
Electrical Characteristics
DC PARAMETERS: DRIFT LIMITS
(The following conditions apply to all the following parameters, unless otherwise specified.)
DC: Rl = 100Ohms, Vs = +5V dc, Vhigh = +3V, Vlow = -3V, Av = +32, (Rf) = 1.5kOhms, (Rg) = 48.3Ohms.
"Deltas not required on B-level product. Deltas required for S-level (-MLS) product as specified on
Internal Processing Instructions (IPI)." (note 3)
SYMBOL
+Iin
PARAMETER
Input Bias
Current
(noninverting)
CONDITIONS
Rs = 50 Ohms
NOTES
PIN-
NAME
MIN
MAX
UNIT
SUB-
GROUPS
+2.5 uA 1
-Iin
Input Bias
Current
(inverting)
Rs = 50 Ohms
+3.0 uA 1
Vio
Input Offset
Rs = 50 Ohms
Voltage
+0.3 mV 1
Is
Supply Current
No Load
+2.4 mA 1
Note 1:
Note 2:
Note 3:
If not tested, shall be guaranteed to the limits specified in table I herein.
Group A testing only.
The limiting terms, "Min" (minimum) and "Max" (maximum) shall be considered to apply
to magnitudes only. Negative current shall be defined as conventional current flow
out of a device terminal.
8