LMC8101TP Datasheet, PDF (5/19 Pages) National Semiconductor (TI) – Rail-to-Rail Input and Output, 2.7V Op Amp in micro SMD package with Shutdown

±5V Electrical Characteristics (Continued)
Unless otherwise specified, all limits guaranteed for T_J = 25˚C, V⁺ =5V, V^− = −5V, V_CM = V_O = 0V, and R_L > 1 MΩ to gnd.
Boldface limits apply at the temperature extremes.
Symbol
Parameter
Conditions
Typ
(Note 5)
Limit
(Note 6)
Units
SR
f_u
GBW
Slew Rate
(Note 8)
Unity Gain-Bandwidth
Gain Bandwidth Product
A_V = +10, R_L = 10kΩ,
1.2
V_O = 10Vpp, C_L = 1000pF
V_I = 10mV
840
R_L = 2kΩ
f = 10KHz
1.3
V/µs
KHz
MHz
e_n
Input-Referred Voltage Noise
f = 10KHz, R_s = 50Ω
33
i_n
Input-Referred Current Noise
f = 10KHz
1.5
THD
Total Harmonic Distortion
f = 10KHz, AV = +1,
0.2
%
V_O =8Vpp, R_L = 600Ω
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications and the test conditions, see the Electrical Characteristics.
Note 2: Human body model, 1.5kΩ in series with 100pF.
Note 3: Applies to both single-supply and split-supply operation. Continuous short circuit operation at elevated ambient temperature can result in exceeding the
maximum allowed junction temperature at 150˚C. Output currents in excess of 40mA over long term may adversely affect reliability.
Note 4: The maximum power dissipation is a function of T_J(MAX), θ_JA and T_A. The maximum allowable power dissipation at any ambient temperature is
P_D = (T_J(MAX) − T_A)/θ_JA. All numbers apply for packages soldered directly onto a PC board.
Note 5: Typical Values represent the most likely parametric norm.
Note 6: All limits are guaranteed by testing or statistical analysis.
Note 7: Positive current corresponds to current flowing into the device.
Note 8: Slew rate is the slower of the rising and falling slew rates.
Note 9: Shutdown Turn-on and Turn-off times are defined as the time required for the output to reach 90% and 10%, respectively, of its final peak to peak swing
when set for Rail to Rail output swing with a 100KHz sine wave, 2KΩ load, and A_V = +10.
Note 10: Limiting input pin current is only necessary for input voltages that exceed absolute maximum input voltage ratings.
Note 11: Short circuit test is a momentary test. See Note 12.
Note 12: Output short circuit duration is infinite for V_S < 6V. Otherwise, extended period output short circuit may damage the device.
Note 13: machine Model, 0Ω in series with 200pF.
5
www.national.com