LMH6574 Datasheet, PDF (4/15 Pages) National Semiconductor (TI) – 4:1 High Speed Video Multiplexer

±3.3V Electrical Characteristics (Continued)
V_S = ±3.3V, R_L = 100Ω, A_V=2 V/V; Unless otherwise specified.
Symbol
Parameter
Conditions (Note 2)
IBN
PSRR
Input Bias Current (Note 7)
Power Supply Rejection Ratio
V_IN = 0V
DC, Input Referred
ICC
Supply Current
No Load
VIH
Logic High Threshold
Select & Enable Pins (SD & EN)
VIL
Logic Low Threshold
Select & Enable Pins (SD & EN)
Miscellaneous Performance
RIN+
Input Resistance
CIN
Input Capacitance
ROUT
Output Resistance
VO
Output Voltage Range
No Load
VOL
CMIR
Input Voltage Range
R_L = 100Ω
IO
Linear Output Current
ISC
Short Circuit Current
V_IN = 0V
V_IN = ±1V, Output shorted to
ground
Min
Typ
Max
Units
-3
µA
49
dB
12
mA
1.3
V
0.4
V
5
kΩ
0.8
pF
0.06
Ω
±2
V
±1.8
V
±1.2
V
±60
mA
±150
mA
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications, see the Electrical Characteristics tables.
Note 2: Electrical Table values apply only for factory testing conditions at the temperature indicated. Factory testing conditions result in very limited self-heating of
the device such that T_J = T_A. No guarantee of parametric performance is indicated in the electrical tables under conditions of internal self heating where T_J > T_A.
See Applications Section for information on temperature de-rating of this device. Min/Max ratings are based on product testing, characterization and simulation.
Individual parameters are tested as noted.
Note 3: The maximum output current (I_OUT) is determined by the device power dissipation limitations (The junction temperature cannot be allowed to exceed
150˚C). See the Power Dissipation section of the Application Section for more details. A short circuit condition should be limited to 5 seconds or less.
Note 4: Human Body model, 1.5kΩ in series with 100pF. Machine model, 0Ω In series with 200pF
Note 5: Parameters guaranteed by electrical testing at 25˚C.
Note 6: Parameters guaranteed by design.
Note 7: Positive Value is current into device.
www.national.com
4