DP83847 Datasheet, PDF (1/60 Pages) National Semiconductor (TI) – DsPHYTER II ㅡ Single 10/100 Ethernet Transceiver

February 2002
DP83847 DsPHYTER II — Single 10/100 Ethernet Transceiver
General Description
Features
The DP83847 is a full feature single Physical Layer device
with integrated PMD sublayers to support both 10BASE-T
and 100BASE-TX Ethernet protocols over Category 3 (10
Mb/s) or Category 5 unshielded twisted pair cables.
The DP83847 is designed for easy implementation of
10/100 Mb/s Ethernet home or office solutions. It interfaces
to Twisted Pair media via an external transformer. This
device interfaces directly to MAC devices through the IEEE
802.3u standard Media Independent Interface (MII) ensur-
ing interoperability between products from different ven-
dors.
The DP83847 utilizes on chip Digital Signal Processing
(DSP) technology and digital Phase Lock Loops (PLLs) for
robust performance under all operating conditions,
enhanced noise immunity, and lower external component
count when compared to analog solutions.
Applications
s Low-power 3.3V, 0.18µm CMOS technology
s Power consumption < 351mW (typical)
s 5V tolerant I/Os
s 5V/3.3V MAC interface
s IEEE 802.3 ENDEC, 10BASE-T transceivers and filters
s IEEE 802.3u PCS, 100BASE-TX transceivers and filters
s IEEE 802.3 compliant Auto-Negotiation
s Output edge rate control eliminates external filtering for
Transmit outputs
s BaseLine Wander compensation
s IEEE 802.3u MII (16 pins/port)
s LED support (Link, Rx, Tx, Duplex, Speed, Collision)
s Single register access for complete PHY status
s 10/100 Mb/s packet loopback BIST (Built in Self Test)
s 56-pin LLP package (9w) x (9l) x (.75h) mm
s LAN on Motherboard
s Embedded Applications
System Diagram
Ethernet MAC
MII
DP83847
10/100 Mb/s
DsPHYTER II
25 MHz
Clock
Status
LEDs
Typical DsPHYTER II application
RJ-45
10BASE-T
or
100BASE-TX
©2002 National Semiconductor Corporation
www.national.com