UPG132G Datasheet, PDF (3/14 Pages) NEC – L-BAND SPDT SWITCH

µPG132G
RECOMMENDED OPERATING CONDITIONS
PARAMETER
Control Voltage (ON)
Control Voltage (OFF)
Input Power Level
SYMBOL
VCONT
VCONT
Pin
MIN.
+2.7
–0.2
TYP.
+3.0
0
27
MAX.
+5.0
+0.2
29
UNIT
V
V
dBm
ELECTRICAL CHARACTERISTICS (TA = 25 ˚C)
CHARACTERISTICS
Insertion Loss
Isolation
Input Return Loss
Output Return Loss
Input Power at 1dB
Compression Point
Switching Speed
Control Current
SYMBOL MIN. TYP. MAX.
LINS
0.6
1.0
0.8^Note1
ISL
20
22
20^Note1
RLin
11
RLout
11
Pin (1dB)^Note2 27
30
tsw
ICONT
30
50
UNIT
dB
dB
dB
dB
dBm
ns
µA
TEST CONDITION
f = 2.5 GHz
f = 2.5 GHz
f = 100 MHz to 2 GHz
VCONT1 = 0 V
VCONT2 = +3 V
or
VCONT1 = +3 V
VCONT2 = 0 V
Notes 1: Characteristic for reference at 2.0 to 2.5 GHz.
2: Pin (1dB) is measured the input power level when the insertion loss increase more 1dB than that of linear
range.
All other characteristics are measured in linear range.
NOTE ON CORRECT USE
• When the µPG132G is used it is necessary to use DC blocking capacitor for No. 2 pin (OUT2), No. 5 pin (IN) and
No. 7 pin (OUT1). The value of DC blocking capacitors should be chosen to accommodate the frequency of
operation.
• Insertion loss and isolation of the IN-OUT2 is better than that of IN-OUT1, because No. 7 pin (OUT1) is placed
to same side of No. 5 pin (IN).
• The distance between IC’s GND pins and ground pattern of substrate should be as shorter as possible to avoid
parasitic parameters.
3