DEBB33A102KA2B Datasheet, PDF (73/83 Pages) Murata Manufacturing Co., Ltd. – Safety Standard Certified Ceramic Capacitors/ High Voltage Ceramic Capacitors

!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
C85E.pdf
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please review our product specifications or consult the approval sheet for product specifications before ordering.
Jul.13,2011
Safety Standard Certified Type KJ for AuTtoympeotKivJeSSppeecciiffiications and Teesstt MMeetthhooddss
Continued from the preceding page.
No.
Item
Specifications
Test Method
The capacitor should be subjected to applied flame for 15 sec.
and then removed for 15 sec. until 5 cycles are completed.
15 Flame Test
Robustness
16 of
Terminations
Tensile
Bending
The capacitor flame extinguishes as follows.
Cycle
1 to 4
5
Time (sec.)
30 max.
60 max.
Lead wire should not be cut off. Capacitor should
not be broken.
76
Capacitor
Flame
127
38
Gas Burner: Inside Dia. 9.5
(in mm)
As shown in the figure at right, fix the body
of the capacitor and apply a tensile weight
gradually to each lead wire in the radial
direction of the capacitor up to 10N and keep
it for 10±1 sec.
W
Each lead wire should be subjected to 5N of weight and bent
90° at the point of egress, in one direction, then returend to
its original position and bent 90° in the opposite direction at the
rate of one bend in 2 to 3 sec.
The capacitor should be individually wrapped in at least one,
but not more than two, complete layers of cheesecloth. The
capacitor should be subjected to 20 discharges. The interval
between successive discharges should be 5 sec. The UAC
should be maintained for 2 min. after the last discharge.
S1
F L1
L2
R
C1 C2
C3 Cx
Ct
Ut
Tr ^{S2 UAC L3}
L4
17 Active Flammability
The cheesecloth should not catch on fire.
Oscilloscope
C1,2 : 1µF±10%
C3 : 0.033µF±5% 10kV
L1 to 4 : 1.5mH±20% 16A Rod core choke
Ct : 3µF±5% 10kV
R
: 100Ω±2%
Cx : Capacitor under test UAC : UR±5%
F : Fuse, Rated 10A
UR : Rated Voltage
Ut
: Voltage applied to Ct
Ux
5kV
18 Passive Flammability
The burning time should not exceed 30 sec.
The tissue paper should not ignite.
time
The capacitor under test should be held in the flame in the
position that best promotes burning. Each specimen should
only be exposed once to the flame. Time of exposure to flame:
30 sec.
Length of flame : 12±1mm
Gas burner : Length 35mm min.
Inside Dia. 0.5±0.1mm
Outside Dia. 0.9mm max.
Gas
: Butane gas Purity 95% min.
Test Specimen
12
45°
* "Room condition" Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmospheric pressure: 86 to 106kPa
Tissue
About 10mm Thick Board
Continued on the following page.
71