64001-3900 Datasheet, PDF (9/9 Pages) Molex Electronics Ltd. – Hand Crimp Tool Operating Instruction Sheet and Specifications

MCT-8200 Hand Crimp Tool
Certificate of Calibration
Tool Order Number ____________________________
Tool Eng. Number_____________________________
Tool Revision________________________________
Serial Number_______________________________
Date of Manufacture___________________________
Handle Load Range; see Tool Preload (page 6). =______________
Actual =_______________
Pin Gauge of Conductor Nest/Nests or Slug height if the nest is the “F” Crimp style.
Range Conductor Nest # 1 =______________Actual =_____________
Range Conductor Nest # 2 =______________Actual =_____________
Range Conductor Nest # 3 =______________Actual =_____________
Range Conductor Nest # 4 =______________Actual =_____________
Technician________________________
Date of Calibration ___________________
Calibration should be done every 5,000 cycles or 3 months.
Tools should be lubricated during this operation.
Americas Headquarters
Lisle, Illinois 60532 U.S.A.
1-800-78MOLEX
[e-mail]
Far East North Headquarters
Yamato, Kanagawa, Japan
81-462-65-2324
[e-mail]
Far East South Headquarters
Jurong, Singapore
65-6-268-6868
[e-mail]
European Headquarters
Munich, Germany
49-89-413092-0
[e-mail]
Visit our Web site at http://www.molex.com
Corporate Headquarters
2222 Wellington Ct.
Lisle, IL 60532 U.S.A.
630-969-4550
Fax: [phone]
Doc. No: ATS-640013900 Release Date: 09-26-03
Revision: K
Revision Date: 05-06-08
UNCONTROLLED COPY
Page 9 of 9