M34513M2 Datasheet, PDF (6/106 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER

PRELIMINARY _{NSocothimcaene:gpTeah.riasmisetnrioct} ^{laimfiintsalasrepescuibfijceacttioton.}
MITSUBISHI MICROCOMPUTERS
4513/4514 Group
SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
PERFORMANCE OVERVIEW
Parameter
Function
Number of
4513 Group 123
basic instructions
4514 Group 128
Minimum instruction execution time
0.75 µs (at 4.0 MHz oscillation frequency, in high-speed mode)
Memory sizes ROM M34513M2 2048 words ! 10 bits
M34513M4/E4 4096 words ! 10 bits
M34513M6 6144 words ! 10 bits
M34513M8/E8 8192 words ! 10 bits
M34514M6 6144 words ! 10 bits
M34514M8/E8 8192 words ! 10 bits
RAM M34513M2 128 words ! 4 bits
M34513M4/E4 256 words ! 4 bits
M34513M6 384 words ! 4 bits
M34513M8/E8 384 words ! 4 bits
M34514M6 384 words ! 4 bits
M34514M8/E8 384 words ! 4 bits
Input/Output D0–D7
ports
I/O (Input is Eight independent I/O ports;
examined by ports D6 and D7 are also used as CNTR0 and CNTR1, respectively.
skip decision)
P00–P03 I/O
P10–P13 I/O
P20–P22 Input
P30–P33 I/O
P40–P43 I/O
P50–P53 I/O
CNTR0 I/O
CNTR1 I/O
INT0 Input
INT1 Input
Timers
Timer 1
Timer 2
Timer 3
Timer 4
A-D converter
Voltage comparator
Serial I/O
Interrupt
Sources
Nesting
Subroutine nesting
Device structure
Package
4513 Group
4514 Group
Operating temperature range
Supply voltage
Power
Active mode
dissipation
(typical value)
RAM back-up mode
4-bit I/O port; each pin is equipped with a pull-up function and a key-on wakeup function. Both
functions can be switched by software.
4-bit I/O port; each pin is equipped with a pull-up function and a key-on wakeup function. Both
functions can be switched by software.
3-bit input port; ports P20, P21 and P22 are also used as SCK, SOUT and SIN, respectively.
4-bit I/O port (2-bit I/O port for the 4513 Group); ports P30 and P31 are also used as INT0 and
INT1, respectively. The 4513 Group does not have ports P32, P33.
4-bit I/O port; The 4513 Group does not have this port.
4-bit I/O port with a direction register; The 4513 Group does not have this port.
1-bit I/O; CNTR0 pin is also used as port D6.
1-bit I/O; CNTR1 pin is also used as port D7.
1-bit input; INT0 pin is also used as port P30 and equipped with a key-on wakeup function.
1-bit input; INT1 pin is also used as port P31 and equipped with a key-on wakeup function.
8-bit programmable timer with a reload register.
8-bit programmable timer with a reload register is also used as an event counter.
8-bit programmable timer with a reload register.
8-bit programmable timer with a reload register is also used as an event counter.
10-bit wide, This is equipped with an 8-bit comparator function.
2 circuits (CMP0, CMP1)
8-bit ! 1
8 (two for external, four for timer, one for A-D, and one for serial I/O)
1 level
8 levels
CMOS silicon gate
32-pin plastic molded SDIP (32P4B)/LQFP(32P6B-A)
42-pin plastic molded SSOP (42P2R-A)
–20 °C to 85 °C
2.0 V to 5.5 V for Mask ROM version, 2.5 V to 5.5 V for One Time PROM version (Refer to the
electrical characteristics because the supply voltage depends on the oscillation frequency.)
1.8 mA (at VDD = 5.0 V, 4.0 MHz oscillation frequency, in middle- speed mode, output transis-
tors in the cut-off state)
3.0 mA (at VDD = 5.0 V, 4.0 MHz oscillation frequency, in high-speed mode, output transistors
in the cut-off state)
0.1 µA (at room temperature, VDD = 5 V, output transistors in the cut-off state)
6