PS21267-P-AP Datasheet, PDF (5/10 Pages) Mitsubishi Electric Semiconductor – AC100V~200V three-phase inverter drive for small power motor control.

MITSUBISHI SEMICONDUCTOR <Dual-In-Line Package Intelligent Power Module>
PS21267-P/AP
TRANSFER-MOLD TYPE
INSULATED TYPE
MECHANICAL CHARACTERISTICS AND RATINGS
Parameter
Mounting torque
Weight
Heat-sink flatness
Note 6 :
Condition
Limits
Unit
Min.
Typ.
Max.
Mounting screw : M4
Recommended : 1.18 N·m 0.98
—
1.47 N·m
—
54
—
g
(Note 6) –50
—
100
µm
+–
Heat sink
Measurement point
–
+
3mm
Place to contact
a heat sink
Heat sink
RECOMMENDED OPERATION CONDITIONS
Symbol
Parameter
Condition
Recommended value
Min.
Typ.
Max. ^Unit
VCC
VD
VDB
∆VD, ∆VDB
tdead
fPWM
Supply voltage
Control supply voltage
Control supply voltage
Control supply variation
Arm shoot-through blocking time
PWM input frequency
Applied between P-N
Applied between VP1-VPC, VN1-VNC
Applied between VUFB-VUFS, VVFB-VVFS, VWFB-VWFS
For each input signal, TC ≤ 100°C
TC ≤ 100°C, Tj ≤ 125°C
0
13.5
13.0
–1
2
—
300
15.0
15.0
—
—
—
400
V
16.5
V
18.5
V
1
V/µs
—
µs
20
kHz
IO
Allowable r.m.s. current
PWIN(on)
Minimum input pulse width
PWIN(off)
VCC = 300V, VD = VDB = 15V, fPWM = 5kHz
—
P.F = 0.8, sinusoidal PWM
TC ≤ 100°C, Tj ≤ 125°C (Note 7) ^{fPWM = 15kHz}
—
(Note 8) 0.3
200 ≤ VCC ≤ 350V,
13.5 ≤ VD ≤ 16.5V,
Below rated current
1.5
13.0 ≤ VDB ≤ 18.5V,
–20°C ≤ TC ≤ 100°C,
Between rated current and
1.7 times of rated current
3.0
N-line wiring inductance less Between 1.7 times and
than 10nH
(Note 9) 2.0 times of rated current
3.6
—
19.0
Arms
—
11.6
—
—
—
—
—
—
µs
—
—
VNC
VNC variation
between VNC-N (including surge)
–5.0
—
5.0
V
Note 7 : The Allowable r.m.s. current value depends on the actual application conditions.
8 : Input signal with ON pulse width less than PWIN(on) might make no response.
9 : IPM might make no response or response delay to next turn-on pulse if off-pulse width is less than PWIN(off). (Please refer to Fig. 4)
Please refer to Fig. 9 for recommended wiring method too.
Oct. 2005