PS21267-P-AP Datasheet, PDF (3/10 Pages) Mitsubishi Electric Semiconductor – AC100V~200V three-phase inverter drive for small power motor control.

MITSUBISHI SEMICONDUCTOR <Dual-In-Line Package Intelligent Power Module>
PS21267-P/AP
TRANSFER-MOLD TYPE
INSULATED TYPE
MAXIMUM RATINGS (Tj = 25°C, unless otherwise noted)
INVERTER PART
Symbol
Parameter
Condition
Ratings
Unit
VCC
Supply voltage
Applied between P-N
450
V
VCC(surge) Supply voltage (surge)
Applied between P-N
500
V
VCES
Collector-emitter voltage
600
V
±IC
±ICP
Each IGBT collector current
Each IGBT collector current (peak)
TC = 25°C
TC = 25°C, less than 1ms
30
A
60
A
PC
Collector dissipation
Tj
Junction temperature
TC = 25°C, per 1 chip
55.5
W
(Note 1)
–20~+125
°C
Note 1 : The maximum junction temperature rating of the power chips integrated within the DIP-IPM is 150°C (@ TC ≤ 100°C) however, to in-
sure safe operation of the DIP-IPM, the average junction temperature should be limited to Tj(ave) ≤ 125°C (@ TC ≤ 100°C).
CONTROL (PROTECTION) PART
Symbol
Parameter
VD
Control supply voltage
VDB
Control supply voltage
VIN
Input voltage
VFO
Fault output supply voltage
IFO
Fault output current
VSC
Current sensing input voltage
Condition
Applied between VP1-VPC, VN1-VNC
Applied between VUFB-VUFS, VVFB-VVFS,
VWFB-VWFS
Applied between UP, VP, WP-VPC, UN, VN,
WN-VNC
Applied between FO-VNC
Sink current at FO terminal
Applied between CIN-VNC
Ratings
Unit
20
V
20
V
–0.5~VD+0.5
V
–0.5~VD+0.5
V
1
mA
–0.5~VD+0.5
V
TOTAL SYSTEM
Symbol
Parameter
VCC(PROT)
Self protection supply voltage limit
(short circuit protection capability)
TC
Module case operation temperature
Tstg
Storage temperature
Viso
Isolation voltage
Note 2 : TC measurement point
Control terminals
Condition
VD = 13.5~16.5V, Inverter part
Tj = 125°C, non-repetitive, less than 2 µs
(Note 2)
60Hz, Sinusoidal, AC 1 minute, connecting
pins to heat-sink plate
Ratings
400
–20~+100
–40~+125
2500
Unit
V
°C
°C
Vrms
TC
Power terminals
Heat sink
TC
Heat sink boundary
Oct. 2005