JANSR2N2907AUB Datasheet, PDF (3/6 Pages) Microsemi Corporation – ABSOLUTE MAXIMUM RATINGS (TC = +25°C unless otherwise noted)

6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / [phone] / Fax: [phone]
Website: http: //www.microsemi.com
TECHNICAL DATA SHEET
PACKAGE DIMENSIONS
NOTES:
1. Dimensions are in inches.
2. Millimeters are given for general information only.
3. Beyond r (radius) maximum, TW shall be held for a minimum length
of .011 inch (0.28 mm).
4. Dimension TL measured from maximum HD.
5. Body contour optional within zone defined by HD, CD, and Q.
6. Leads at gauge plane .054 +.001 -.000 inch (1.37 +0.03 -0.00 mm)
below seating plane shall be within .007 inch (0.18 mm) radius of
true position (TP) at maximum material condition (MMC) relative to
tab at MMC.
7. Dimension LU applies between L₁ and L₂. Dimension LD applies
between L₂ and LL minimum. Diameter is uncontrolled in L₁ and
beyond LL minimum.
8. All three leads.
9. The collector shall be internally connected to the case.
10. Dimension r (radius) applies to both inside corners of tab.
11. In accordance with ASME Y14.5M, diameters are equivalent to φx
symbology.
12. Lead 1 = emitter, lead 2 = base, lead 3 = collector.
13. For L suffix devices, dimension LL = 1.5 inches (38.10 mm) min.
and 1.75 inches (44.45 mm) max.
Symbol
CD
CH
HD
LC
LD
LL
LU
L₁
L₂
P
Q
TL
TW
r
α
Dimensions
Inches
Millimeters
Min Max Min Max
.178 .195 4.52 4.95
.170 .210 4.32 5.33
.209 .230 5.31 5.84
.100 TP
2.54 TP
.016 .021 0.41 0.53
.500 .750 12.70 19.05
.016 .019 0.41 0.48
.050
1.27
.250
6.35
.100
2.54
.030
0.76
.028 .048 0.71 1.22
.036 .046 0.91 1.17
.010
0.25
45° TP
45° TP
Note
6
7,8
7,8,13
7,8
7,8
7,8
5
3,4
3
10
6
T4-LDS-0055 Rev. 4 (100247)
FIGURE 1. Physical dimensions (similar to TO-18)
Page 3 of 6