JANS2N5339 Datasheet, PDF (3/4 Pages) Microsemi Corporation – NPN POWER SILICON SWITCHING TRANSISTOR

6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / [phone] / Fax: [phone]
Website: http://www.microsemi.com
TECHNICAL DATA SHEET
Gort Road Business Park, Ennis, Co. Clare, Ireland
Tel: [phone] Fax: [phone]
PACKAGE DIMENSIONS
Symbol
CD
CH
HD
LC
LD
LL
LU
L₁
L₂
TL
TW
P
Q
r
α
Notes
Dimensions
Inches
Millimeters
Min Max Min Max
.305 .355 7.75 9.02
.240 .260 6.10 6.60
.335 .370 8.51 9.40
.200 TP
5.08 TP
.016 .021 0.41 0.53
.500 .750 12.70 19.05
.016 .019 0.41 0.48
.050
1.27
.250
6.35
.029 .045 0.74 1.14
.028 .034 0.71 0.86
.100
2.54
.050
1.27
.010
0.25
45° TP
45° TP
1, 2, 8, 9
1, 2, 8, 9
Note
5
3
6
7
7
7
7
7
3
10
5
4
10, 11
6
NOTES:
1. Dimensions are in inches.
2. Millimeters are given for general information only.
3. Symbol TL is measured from HD maximum.
4. Details of outline in this zone are optional.
5. Symbol CD shall not vary more than .010 (0.25 mm) in zone P. This zone is controlled for automatic handling.
6. Leads at gauge plane .054 inch (1.37 mm) +.001 inch (0.03 mm) -.000 inch (0.00 mm) below seating plane shall be
within .007 inch (0.18 mm) radius of true position (TP) relative to tab. Device may be measured by direct methods or by
gauge.
7. Symbol LD applies between L1 and L2. Dimension LD applies between L2 and LL minimum.
8. Lead designation, depending on device type, shall be as follows:
Lead number TO-39
1
Emitter
2
Base
3
Collector
9. Lead number three is electrically connected to case.
10. Beyond r maximum, TW shall be held for a minimum length of .011 inch (0.28 mm).
11. Symbol r applied to both inside corners of tab.
12. In accordance with ASME Y14.5M, diameters are equivalent to φx symbology.
FIGURE 1. Physical dimensions (TO-39)
T4-LDS-0011 Rev. 3 (101764)
Page 3 of 4