JAN2N1131 Datasheet, PDF (3/3 Pages) Microsemi Corporation – LOW POWER PNP SILICONTRANSISTOR

6 Lake Street, Lawrence, MA 01841
1-800-446-1158 / [phone] / Fax: [phone]
Website: http: //www.microsemi.com
TECHNICAL DATA SHEET
Gort Road Business Park, Ennis, Co. Clare, Ireland
Tel: [phone] Fax: [phone]
PACKAGE DIMENSIONS
Symbol
CD
CH
HD
LC
LD
LL
LU
L₁
L₂
P
Q
TL
TW
r
α
Dimensions
Inches
Millimeters
Min Max Min Max
.305 .335 7.75 8.51
.240 .260 6.10 6.60
.335 .370 8.51 9.40
.200 TP
5.08 TP
.016 .021 0.41 0.53
.500 .750 12.70 19.05
.016 .019 0.41 0.48
.050
1.27
.250
6.35
.100
2.54
.050
1.27
.029 .045 0.74 1.14
.028 .034 0.71 0.86
.010
0.25
45° TP
45° TP
Note
6
7, 8
7, 8, 12
7, 8
7, 8
7, 8
5
4
3
10
6
NOTES:
1. Dimensions are in inches.
2. Millimeters are given for general information only.
3. Beyond r (radius) maximum, TW shall be held for a minimum length of .011 inch (0.28 mm).
4. Dimension TL measured from maximum HD.
5. Body contour optional within zone defined by HD, CD, and Q.
6. CD shall not vary more than .010 inch (0.25 mm) in zone P. This zone is controlled for automatic handling.
7. Leads at gauge plane .054 +.001, -.000 inch (1.37 +0.03, -0.00 mm) below seating plane shall be within .007 inch (0.18
mm) radius of true position (TP) at maximum material condition (MMC) relative to tab at MMC. The device may be
measured by direct methods or by gauging procedure.
8. Dimension LU applies between L₁ and L₂. Dimension LD applies between L₂ and LL minimum. Diameter is
uncontrolled in and beyond LL minimum.
9. All three leads.
10. The collector shall be internally connected to the case.
11. Dimension r (radius) applies to both inside corners of tab.
12. In accordance with ASME Y14.5M, diameters are equivalent to φx symbology.
13. Lead 1 = emitter, lead 2 = base, lead 3 = collector.
14. * For L-suffix or non-S-suffix devices (TO-5), dimension LL = 1.5 inches (38.10 mm) min. and 1.75 inches (44.45 mm)
max. For non-L suffix types (TO-39), dimension LL = .5 inch (12.70 mm) min. and .750 inch (19.05 mm) max..
* FIGURE 1. Physical dimensions 2N1131 and 2N1132 ( TO-39), 2N1131L and 2N1132L (TO-5).
T4-LDS-0187 Rev. 1 (101882)
Page 3 of 3