PC28F640P33BF60A Datasheet, PDF (45/88 Pages) Micron Technology – Numonyx® P33-65nm Flash Memory

P33-65nm SBC
13.0 Maximum Ratings and Operating Conditions
13.1
Absolute Maximum Ratings
Warning:
Stressing the device beyond the Absolute Maximum Ratings may cause permanent
damage. These are stress ratings only.
Table 18: Absolute Maximum Ratings
Parameter
Maximum Rating
Notes
Temperature under bias
–40 °C to +85 °C
-
Storage temperature
–65 °C to +125 °C
-
Voltage on any input/output signal (except VCC, VPP and VCCQ)
–2.0 V to +5.6 V
1
VPP voltage
–2.0 V to +11.5 V
1,2
VCC voltage
–2.0 V to +5.6 V
1
VCCQ voltage
–2.0 V to +5.6 V
1
Output short circuit current
100 mA
3
Notes:
1.
Voltages shown are specified with respect to V_SS. During infrequent non-periodic transitions, the level may undershoot
to –2.0 V for periods less than 20 ns or overshoot to VCC + 2.0 V or VCCQ + 2.0 V for periods less than 20 ns.
2.
Program/erase voltage is typically 2.3 V ~ 3.6 V. 9.0 V can be applied for 80 hours maximum total. 9.0 V program/erase
voltage may reduce block cycling capability.
3.
Output shorted for no more than one second. No more than one output shorted at a time.
13.2
Operating Conditions
Note:
Operation beyond the Operating Conditions is not recommended and extended
exposure beyond the Operating Conditions may affect device reliability.
Table 19: Operating Conditions
Symbol
Parameter
T_C
VCC
Operating Temperature
VCC Supply Voltage
VCCQ I/O Supply Voltage
CMOS inputs
TTL inputs
V_PPL
V_PP Voltage Supply (Logic Level)
V_PPH
Buffered Enhanced Factory Programming V_PP
t_PPH
Maximum V_PP Hours
VPP = V_PPH
Block
Erase
Cycles
Main and Parameter Blocks
Main Blocks
Parameter Blocks
VPP = V_PPL
VPP = V_PPH
VPP = V_PPH
Notes:
1.
T_C = Case Temperature.
2.
In typical operation VPP program voltage is V_PPL.
Min
–40
2.3
2.3
2.4
1.5
8.5
-
100,000
-
-
Max
+85
3.6
3.6
3.6
3.6
9.5
80
-
1000
2500
Units
°C
V
Notes
1
-
-
Hours
2
Cycles
Datasheet
45
Jul 2011
Order Number:208034-04