41228F Datasheet, PDF (7/22 Pages) –

PIC10F200/202/204/206
3.2.1.3 Increment Address
The PC is incremented when this command is
received. A timing diagram of this command is shown
in Figure 3-7.
It is not possible to decrement the address counter. To
reset this counter, the user must either exit and re-enter
Program/Verify mode or increment the PC from 0x1FF
for the PIC10F200/204 or 0x3FF for the PIC10F202/
206 to 0x000.
FIGURE 3-7:
INCREMENT ADDRESS COMMAND
ICSPCLK
1
2
3
4
5
TDLY2
6
1
Next Command
2
ICSPDAT
0
1
1
0
x
x
TSET1
THLD1
3.2.1.4
Begin Programming (Externally
Timed)
A Load command must be given before every Begin
Programming command. Programming will begin after
this command is received and decoded. Programming
requires (TPROG) time and is terminated using an End
Programming command. This command programs the
current location, no erase is performed.
FIGURE 3-8:
BEGIN PROGRAMMING (EXTERNALLY TIMED)
ICSPCLK
ICSPDAT
TPROG
End Programming Command
1
2
3
4
5
6
1
2
0
0
0
1
x
x
TSET1
THLD1
0
1
 2007-2011 Microchip Technology Inc.
Advance Information
DS41228F-page 7