DSPIC33FJ32GP302_12 Datasheet, PDF (346/436 Pages) Microchip Technology – 16-bit Digital Signal Controllers (up to 128 KB Flash and 16K SRAM) with Advanced Analog

dsPIC33FJ32GP302/304, dsPIC33FJ64GPX02/X04, AND dsPIC33FJ128GPX02/X04
TABLE 30-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS (CONTINUED)
Standard Operating Conditions: 3.0V to 3.6V
DC CHARACTERISTICS
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Param
No.
Symbol
Characteristic
Min
Typ⁽¹⁾ Max Units
Conditions
IICL
Input Low Injection Current
DI60a
0
—
-5^(5,8) mA All pins except VDD, VSS,
AVDD, AVSS, MCLR,
VCAP, SOSCI, SOSCO,
and RB14
IICH
Input High Injection Current
DI60b
0
— +5^(6,7,8) mA All pins except VDD, VSS,
AVDD, AVSS, MCLR,
VCAP, SOSCI, SOSCO,
RB14, and digital 5V-tol-
erant designated pins
∑IICT
DI60c
Total Input Injection Current
(sum of all I/O and control
pins)
-20⁽⁹⁾
— +20⁽⁹⁾ mA Absolute instantaneous
sum of all ± input
injection currents from all
I/O pins
( | IICL + | IICH | ) ≤∑IICT
Note 1: Data in “Typ” column is at 3.3V, 25°C unless otherwise stated.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current can be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: See the “Pin Diagrams” section for the 5V tolerant I/O pins.
5: VIL source < (VSS – 0.3). Characterized but not tested.
6: Non-5V tolerant pins VIH source > (VDD + 0.3), 5V tolerant pins VIH source > 5.5V. Characterized but not
tested.
7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5.5V.
8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.
9: Any number and/or combination of I/O pins not excluded under IICL or IICH conditions are permitted pro-
vided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not
exceed the specified limit. Characterized but not tested.
DS70292G-page 346
© 2007-2012 Microchip Technology Inc.