24LC09_04 Datasheet, PDF (2/18 Pages) Microchip Technology – 8K 2.5V ACR SERIAL EEPROM

24LC09
1.0 ELECTRICAL
CHARACTERISTICS
Absolute Maximum Ratings†
VCC.............................................................................................................................................................................7.0V
All inputs and outputs, w.r.t. VSS ....................................................................................................... -0.3V to VCC + 1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied ................................................................................................-65°C to +125°C
Soldering temperature of leads (10 seconds) .......................................................................................................+300°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
†Notice: Stresses above those listed under “Maximum ratings” may cause permanent damage to the device. This is
a stress rating only and functional operation of the device at those or any other conditions above those indicated in
the operational listings of this specification is not implied. Exposure to maximum rating conditions for extended peri-
ods may affect device reliability.
1.1 DC Characteristics
DS Characteristics
Industrial (I):
TAMB = -40°C to +85°C
Param.
No.
Sym
Characteristic
D1
VIH High level input voltage
D2
VIL Low level input voltage
D3
VHYS Hysteresis of Schmitt trigger
Inputs
D4
VOL Low level output voltage
D5
ILI
Input leakage current
D6
ILO Output leakage current
D7 CIN, COUT Pin capacitance
(all inputs/outputs)
D8 ICC WRITE Operating current
D9 ICC READ
D10
ICCS Standby current
Min.
Max.
.7 VCC
—
.05 VCC
—
.3 VCC
—
—
.40
-10
10
-10
10
—
10
—
3
—
1
—
1
—
1
Note: This parameter is periodically sampled and not 100% tested.
Units
Test Conditions
V
V
V (Note)
V IOL = 3.0 mA, VCC = 2.5V
µA VIN = 0.1V to VCC
µA VOUT = 0.1V to VCC
pF VCC = 5.0V, TAMB = 25°C,
FCLK = 1 MHz (Note)
mA VCC = 5.5V,
mA SCL = 400 kHz
µA VCC = 3.0V, SDA = SCL = VCC
µA VCC = 5.5V, SDA = SCL = VCC
WP = VSS
DS21675B-page 2
 2004 Microchip Technology Inc.