DSPIC33FJ64MC204-I Datasheet, PDF (111/460 Pages) Microchip Technology – 16-bit Digital Signal Controllers (up to 128 KB Flash and 16K SRAM) with Motor Control PWM and Advanced Analog

dsPIC33FJ32MC302/304, dsPIC33FJ64MCX02/X04 AND dsPIC33FJ128MCX02/X04
REGISTER 7-14: IEC4: INTERRUPT ENABLE CONTROL REGISTER 4
R/W-0
R/W-0
U-0
DAC1LIE⁽²⁾ DAC1RIE⁽²⁾
—
bit 15
U-0
R/W-0
R/W-0
—
QEI2IE
FLTA2IE
R/W-0
PWM2IE
U-0
—
bit 8
U-0
—
bit 7
R/W-0
C1TXIE⁽¹⁾
R/W-0
DMA7IE
R/W-0
DMA6IE
R/W-0
CRCIE
R/W-0
U2EIE
R/W-0
U1EIE
U-0
—
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13-12
bit 11
bit 10
bit 9
bit 8-7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
DAC1LIE: DAC Left Channel Interrupt Enable bit⁽²⁾
1 = Interrupt request enabled
0 = Interrupt request not enabled
DAC1RIE: DAC Right Channel Interrupt Enable bit⁽²⁾
1 = Interrupt request enabled
0 = Interrupt request not enabled
Unimplemented: Read as ‘0’
QEI2IE: QEI2 Event Interrupt Flag Status bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
FLTA2IE: PWM2 Fault A Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
PWM2IE: PWM2 Error Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
Unimplemented: Read as ‘0’
C1TXIE: ECAN1 Transmit Data Request Interrupt Enable bit⁽¹⁾
1 = Interrupt request occurred
0 = Interrupt request not occurred
DMA7IE: DMA Channel 7 Data Transfer Complete Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
DMA6IE: DMA Channel 6 Data Transfer Complete Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
CRCIE: CRC Generator Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
U2EIE: UART2 Error Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
U1EIE: UART1 Error Interrupt Enable bit
1 = Interrupt request enabled
0 = Interrupt request not enabled
Unimplemented: Read as ‘0’
Note 1: Interrupts are disabled on devices without an ECAN™ module.
2: Interrupts are disabled on devices without an Audio DAC module.
© 2007-2012 Microchip Technology Inc.
DS70291G-page 111