PL502-35 Datasheet, PDF (4/10 Pages) Micrel Semiconductor – 750kHz – 800MHz Low Phase Noise Multiplier VCXO

PL502-35/-37/-38/-39
750kHz – 800MHz Low Phase Noise Multiplier VCXO
Universal Low Phase Noise ICs
2. Crystal Specifications
PARAMETERS
SYMBOL
CONDITIONS
MIN. TYP. MAX. UNITS
Crystal Resonator Frequency
FXIN Parallel Fundamental Mode 12
25 MHz
Crystal Loading Rating
CL (xtal) At VCON = 1.65V
9.5
pF
Crystal Pullability
C0/C1 (xtal) AT cut
250
-
Recommended ESR
RE
AT cut
30
Ω
Note: Crystal Loading rating: 9.5pF is the loading the crystal sees from the VCXO chip at VCON = 1.65V. It is assumed that the cr ystal will be at nom-
inal frequency at this load. If the crystal requires more load to be at nominal frequency, the additiona l load must be added externally. This however
may reduce the pull range.
3. Voltage Control Crystal Oscillator
PARAMETERS
SYMBOL
CONDITIONS
MIN. TYP. MAX. UNITS
VCXO Stabilization Time *
TVCXOSTB From power valid
10
ms
VCXO Tuning Range
FXIN = 12 – 25MHz;
XTAL C0/C1 < 250
0V  VCON  3.3V
500
ppm
CLK output pullability
VCON=1.65V, 1.65V
200
ppm
VCXO Tuning Characteristic
150
ppm/V
Pull range linearity
10
%
VCON pin input impedance
2000
kΩ
VCON modulation BW
0V  VCON  3.3V, -3dB
10
kHz
Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits.
4. General Electrical Specifications
PARAMETERS SYMBOL
CONDITIONS
MIN.
Supply Current,
Dynamic (with
Loaded Outputs)
FOUT <24MHz
IDD
LVPECL/LVDS/
LVCMOS
24MHz< FOUT <96MHz
96MHz< FOUT <800MHz
Operating
Voltage
VDD
2.97
Output Clock Du-
ty Cycle
@ 50% VDD (LVCMOS)
@ 1.25V (LVDS)
@ VDD – 1.3V (LVPECL)
45
45
45
Short Circuit
Current
TYP. MAX. UNITS
60/28/15
65/45/30 mA
100/80/40
3.63
V
50
55
50
55
%
50
55
50
mA
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel [phone] • fax [phone] • www.micrel.com Rev 4/15/13 Page 4